R AY-AP09DJ SPLIT TYPE ROOM AIR CONDITIONER OPERATION MANUAL INDOOR UNIT OUTDOOR UNIT AY-AP09DJ AE -A09DJ
ENGLISH Thank you for purchasing a SHARP air conditioner. Please read this manual carefully before operating the product. CONTENTS • PLASMACLUSTER OPERATION ........ • ONE-HOUR OFF TIMER ...................... • TIMER OPERATION ............................. • AUXILIARY MODE ............................... • MAINTENANCE .................................... • BEFORE CALLING FOR SERVICE ..... • SPECIFICATIONS ................................ • PRECAUTIONS ..............................................
PRECAUTIONS CAUTIONS FOR USE 1 2 3 4 5 6 7 8 9 If a gas appliance is used in the same room as the air conditioner, ventilate the room periodically to prevent oxygen depletion. For safety, do not touch the unit with wet hands, it may cause an electric shock. For safety, turn the circuit breaker off when not using the unit for an extended period of time. For safety, do not place anything on top of the outdoor unit or step on it. This unit is designed for residential use.
ADDITIONAL NOTES ON OPERATION OPERATING TEMPERATURE RANGE INDOOR TEMP. OUTDOOR TEMP. upper limit COOLING lower limit upper limit HEATING lower limit D.B. = Dry-bulb 32˚C 23˚C 21˚C 15˚C 27˚C D.B. W.B. D.B. W.B. D.B. 46˚C D.B. 21˚C D.B. 24˚C D.B. 18˚C W.B. -8.5˚C D.B. -9.5˚C W.B. 20˚C D.B. - • The built-in protective device may prevent the unit from operating when used out of this range.
PART NAMES INDOOR UNIT 1 1 Inlet (Air) 2 2 Open Panel 3 3 Air Filters 4 AUX.
REMOTE CONTROL 1 1 TRANSMITTER 2 DISPLAY (Liquid Crystal Display) 3 ON/OFF Button MODE TEMP. 2 4 THERMO. (Thermostat) Button 5 DISPLAY Button FAN TIMER 3 TEMP. 7 TIMER ON Button (for setting the timer) 4 5 6 7 8 9 0 q w e DISPLAY MODE 1h 6 MODE Button FAN SWING CANCEL 8 ONE-HOUR OFF TIMER Button 9 TIMER OFF Button (for setting the timer) 0 FAN Button q TIMER CANCEL Button w SWING Button e PLASMACLUSTER Button L.C.D.
USING THE REMOTE CONTROL LOADING BATTERIES Use two size-AAA (R03) batteries. the battery cover at the back of 1 Remove the remote control. batteries in the compartment, mak2 Insert ing sure the ± and — polarities are correctly aligned. • Lines will be indicated on the display when batteries are properly installed. 3 Replace the battery cover. Battery cover NOTES: • The battery life is approximately one year in normal use.
TIPS ABOUT PLASMACLUSTER OPERATION The ionizer inside the air conditioner will release cluster ions, which are collective mass of positive and negative ions, into the room. The cluster ions reduce airborne mold fungus. Ionizer Cluster ions Mold fungus AIR CLEAN OPERATION Cluster ions released into the air will reduce airborne mold fungus. ION BALANCE OPERATION It is said that plenty of negative ions exist in places such as waterfalls or watreside in natural environment.
BASIC OPERATION Press the MODE button to select the operation mode. 1 AUTO MODE TEMP. HEAT COOL DRY Press the ON/OFF button to start operation. 2 • The red OPERATION lamp ( unit will light. FAN TIMER TEMP. 2 5 3 FAN ONLY ) on the Press the THERMO. button to set the desired temperature.
TIPS ABOUT AUTO MODE In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. Modes and Temperature Settings Room temp. at operation start-up Below 21°C 21°C-24°C 24°C-26°C 26°C-28°C Above 28°C Mode HEAT DRY COOL COOL COOL Automatic Operation Thermostat Setting 23°C Room Temp.
ADJUSTING THE AIR FLOW DIRECTION VERTICAL AIR FLOW DIRECTION The air flow direction is automatically preset in each mode as follows for optimum comfort: COOL and DRY mode HEAT and FAN ONLY mode Horizontal air flow Diagonal air flow HOW TO ADJUST THE AIR FLOW DIRECTION Press the SWING button on the remote control once. • The vertical adjustment louvre will change its angle continuously. Press the SWING button again when the vertical adjustment louvre is at the desired position.
PLASMACLUSTER OPERATION AIR CLEAN OPERATION : Cluster ions released into air will reduce airborne mold fungus. ION BALANCE OPERATION : Negative ions will be released in an increased rate. 1 MODE TEMP. FAN TIMER During operation, press the PLASMACLUSTER button to select the mode. AIR CLEAN ION BALANCE CANCEL • In the AIR CLEAN operation, the blue PLASMACLUSTER lamp on the unit will light up. • In the ION BALANCE operation, the green PLASMACLUSTER lamp on the unit will light up.
TIMER OPERATION TIMER OFF The unit will turn off automatically according to your setting. Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12 hours. Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12 hours, by 1 hour increment. Point the remote control at the signal receiver window on the unit. MODE TEMP. FAN TIMER Press the TIMER OFF ( 1 time as desired. • The time setting will change as you to press the button as follows. TEMP. 0.
TIMER ON The unit will turn on automatically according to your setting. Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12 hours. Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12 hours, by 1 hour increment. Point the remote control at the signal reciever window on the unit. MODE the TIMER ON ( ) button. 1 Press • The time setting will change as you press the button TEMP. as follows. FAN 0.5h TIMER 1.0h 1.5h 10h 11h 12h TEMP.
AUXILIARY MODE Use this mode when the remote control is not available. TO TURN ON Lift the front panel of the indoor unit and press the AUX. button on the operation panel. • The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode. • The fan speed and temperature setting are set to AUTO. TO TURN OFF Press the AUX. button on the operation panel again. • The red OPERATION lamp ( ) on the unit will turn off. NOTE: If the AUX.
MAINTENANCE Be sure to disconnect the power cord from the wall outlet or turn off the circuit breaker before performing any maintenance. CLEANING THE FILTERS The air filters should be cleaned every two weeks. 1 TURN OFF THE UNIT 2 REMOVE THE FILTERS 1 2 1 Lift the open panel. 2 Push the air filters up slightly to unlock them. 3 Pull the air filters down to remove them. 3 THE FILTERS 3 CLEAN Use a vacuum cleaner to remove dust. If the filters are dirty, wash them with warm water and a mild detergent.
BEFORE CALLING FOR SERVICE The following conditions do not denote equipment malfunctions UNIT DOES NOT OPERATE SWISHING NOISE The unit will not operate if it is turned on immediately after it is turned off. The unit will not operate immediately after the mode is changed. This is to protect the internal mechanisms. Wait 3 minutes before operating the unit. The soft, swishing noise is the sound of the refrigerant flowing inside the unit. UNIT DOES NOT SEND OUT WARM AIR The unit is preheating or de-icing.
SPECIFICATIONS Indoor unit Outdoor unit Rated A.C. voltage (V) Rated freuency (Hz) Cooling capacity (kW)* Heating capacity (kW)* AY-AP09DJ AE-A09DJ 230-240 50 2.5 3.0 *When tested in accordance with AS/NZS3823.1.1.
SHARP CORPORATION OSAKA, JAPAN Printed in Thailand TINSEA359JBRZ 03HO TH 1