Installation Instructions

SAFETY REGULATIONS

CAUTION

1.Insufficient electricity power will shorter the control distance.

2.Insufficient electricity power will lead to diffculties in taking off and ascending.

3.Fix the quadcopter in time if there is any damage.If it is damaged badly

(for example:blade is damaged),it may hurt players.

4.Remove the transmitter batteries if not in use for along time in case of

battery leakage.

5.Avoiding dropping and crashing the quadcopter for it will lead to damages

and shorten the use life.

6.The alloy parts in the quadcopter may hurt you children,please pay much

attention.

3.Keep away from water.

4.Regular check is suggested and damaged parts shall be replaced in time.

1.Small parts shall be well kept far away from children.

2.It is suggested to power up slowly to avoid any potential damage of high

speed.

3.It is suggested to switch off the power of the remote controller before the

quadcopter.

4.The batteries shall be kept away from fire or high temperature.

5.The quadcopter shall be kept an enough distance from others to avoid any

potential injury.

6.Child shall be under the monitoring of an adult in playing the quadcopter.

7.It is prohibited to charge a non-chargeable battery.Batteris shall be installed

in correct direction.It is not allowed to use the old battery and the new battery

at the same time.

8.The switches shall be shut down and the batteries shall be taken out for

long time no use.

9.Be aware of the risk of short circuit.

PdfEditor 4.0.0.14 Testversion - https://www.pixelplanet.com/de/pdfeditor/

PAGE 1
3.Keep away from water. 4.Regular check is suggested and damaged parts shall be replaced in time. SAFETY REGULATIONS 1.Small parts shall be well kept far away from children. 2.It is suggested to power up slowly to avoid any potential damage of high speed. 3.It is suggested to switch off the power of the remote controller before the quadcopter. 4.The batteries shall be kept away from fire or high temperature. 5.The quadcopter shall be kept an enough distance from others to avoid any potential injury. 6.
PAGE 2
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.