User's Manual

ManualsBrandsSHANGHAI WANWAY DIGITAL TECHNOLOGY ManualsElectronicsGPS Tracker

Table Of Contents

G30 User Manual

G30 User Manual

Content

G30 User Manual ................................................................................................................................ 1

1. Product Overview .................................................................................................................... 2

2. Product specifications ............................................................................................................. 2

3. Instructions for use ................................................................................................................. 4

3.1. Start-up and setup process........................................................................................... 4

3.2 Connection Diagram ...................................................................................................... 5

3.3 Application note about SOS and recording function ..................................................... 6

3.4 Application Notes on ACC ON/OFF ................................................................................ 6

3.6 MODE 2 and MODE 21 Operating Modes ..................................................................... 7

3.7 Vehicle Guard Alarm and Low Battery Alarm ................................................................ 8

3.8 Device Photosensitive Alarm Description ..................................................................... 9

3.9 Vehicle collision alarm parameter setting instructions ................................................. 9

3.10 Vehicle acceleration/deceleration and sharp turning parameter settings .................. 9

3.11 About time zone settings and related instructions ................................................... 11

3.14 Common Query Commands ...................................................................................... 11

3.15 Common Setting Instructions .................................................................................... 12

4. Manage your device .............................................................................................................. 12

5. Cautions ................................................................................................................................ 13

Summary of content (13 pages)

PAGE 1
G30 User Manual Content G30 User Manual ................................................................................................................................ 1 1. Product Overview .................................................................................................................... 2 2. Product specifications ............................................................................................................. 2 3. Instructions for use ........................................
PAGE 2
1.
PAGE 3
 GPRS/EDGE: 850MHz Module CLM920_TD3AU: Version for Australia/South America 4G LTE FDD: B5 3G UMTS/HSPA+: B5 GPRS/EDGE: 850MHz  Working Voltage: Input Voltage: 8 - 45V. Applicable for motorcycles, cars, trucks, boats etc .
PAGE 4
3. Instructions for use 3.1. Start-up and setup process After the device is connected to the vehicle power supply, the recommended installation flowchart is as follows: Open the A case waterproof cover Insert the SIM card in the direction shown, apply power supply to the device, and turn the key to ON position. END Check the LED status: 1. Red LED Blink: Network registered; 2. Red LED ON: Server connected. 3. Blue LED Blink: Searching for GPS Fixed. 4. Blue LED ON: GPS Fixed.
PAGE 5
3.2 Connection Diagram Figure1.
PAGE 6
5 Microphone positive/MIC + Brown 6 Microphone negative/MIC-/GND Gray 7 Serial Receive/RXD Orange 8 Serial transmission/TXD 5/6 line can be used as an external MIC [standard function] or NTC temperature detection [optional function] Equipment ground 7/8 line can be used as SOS line access [standard function] Or 6/7/8 line for UART communication, Orange compatible with 3.3V/5.0V UART [optional function] 3.
PAGE 7
2 ACCON1: ACC ON voltage, default 132 ACCOFF1: ACC OFF voltage, default 128 FCG = SET1, ACCON1, ACCOFF1, A # A: Automatic ACC detection 1. Enable the function of judging ACC status configuration for 12V based on voltage (default) battery-powered vehicles such as cars 0, forbidden and motorcycles. Remarks: 132 means 13.
PAGE 8
2 Device intelligent reporting instructions: MODE, 21, , , # instruction Remarks: 1. When ACC OFF: Enter this mode automatically, GPS, 4G will be turned off at this time Module and MCU goes to sleep. 2. When ACC ON: automatically exit this mode and turn on GPS, 4G Module, MCU wakes up. 3. T1, T2, and T3 are the time points reported by the device to wake up after the device sleeps. Format: HHMM 4. Example: MODE, 21,1818 # When the device is in ACC OFF, the daily 18:18 Forced wake-up report.
PAGE 9
3.8 Device Photosensitive Alarm Description 1). Place the device in a dark place for more than 60S. When the mobile device sees light for more than 1S, it will trigger a photosensitive alarm. 1 ALARMMODE,L1/L0 L1 light sensitive: Default is on; L0 light sensitive is off 3.9 Vehicle collision alarm parameter setting instructions Used to adjust parameters according to actual installation and use.
PAGE 10
When GPSGSE, 1 #, the following settings about angle increment and speed increment are valid 2 CARSET, A, B, C, D # instructions A: Sharp turn angle: Degree B: Average turn speed: KM C: Rapid acceleration increment: KM D: Rapid deceleration reduction: KM, default: 75,20,8,18 When GPSGSE, 0 #, the following settings about Gsensor are valid 1 2 3 GSENACC,A# Used to set the sensitivity of device acceleration events (A = 1-6, Default: 5) The following value indicates that the acceleration event will be
PAGE 11
3.11 About time zone settings and related instructions Set time zone: A: E or W B: 0 ~ 12 time zone C: half time zone Example: GMT, E, 8 # 1 GMT,,, 2 USELOCALTZ,1 Associated time zone: The reported data time is synchronized to the set time zone 3 USELOCALTZ,0 Non-associated time zone: The default reported data time is fixed to the time zone of UTC + 8 3.
PAGE 12
3.15 Common Setting Instructions 1 Set server command. SERVER,1,, : server domain or IP : server port LANG, Set language. 1: Chinese 0: English Default: English 3 CENTER,A, Set the center number: PARAM # can check the center number information, which is use for some remote control. 4 CENTER,D, Delete center number. 5 APN, Set APN. 6 APN,AUTOAPN Set to automatic APN. 7 RELAY,0/1# 1: Remote control set.
PAGE 13
5. Cautions 1) Do not short circuit. 2) Do not put in fire or heat. 3) It is strictly prohibited for users to assemble or disassemble the battery by themselves. 4) Do not use outside the allowed temperature range. 5) It is strictly forbidden to knock, disassemble or disassemble this product for repair or modification. 6) The operating temperature environment and usage scenarios of the device will affect the battery discharge efficiency.