User's Manual

SOHO Wireless Router

SN: 0904-0003-014

WAN

LAN

USB

ON/OFF

Reset

The LED indicator blinks twice per second when the system is operating

properly, and it will blink slower if the system is under heavy load.

Insert a TF card for data sharing.

The DC interface is where you connect the provided power adapter.

Press this button to turn the Device on and off.

The LED indicator is yellow when the USB interface is connected

properly, and it is red when the TF port is connected properly.

The WAN interface is connected to your Internet device, such as a cable

or modem.

These interfaces provide a LAN connection to network devices, such as

PCs or switches.

Plug-in a USB storage for data sharing.

The LAN LED indicator is on when Ethernet cable connection is normal,

and it blinks when the LAN port is sending or receiving data.

The WAN LED indicator is on when Ethernet cable connection is normal,

and it blinks when the WAN port is sending or receiving data.

The 5G LED indicator is on when 5GHz Wireless is enabled, and it

blinks when transmitting/receiving 5G wireless data.

The 2.4G LED indicator is on when 2.4GHz Wireless is enabled, and it

blinks when transmitting/receiving 2.4G wireless data.

The Power LED indicator is on when the Device is powered on.

Note: 3. Please install the equipment in a place away from the High

Power Radio or Radar Station.

4. Please KEEP THIS DEVICE AWAY FROM WATER!

5. Please use the provided power adapter.

1. The picture is only for reference. Please make the object as the standard.

2. Please power off the Device and disconnect all cables from the Device

during thunderstorms to avoid possible damage from a lightning strike.

DSL Modem

Reset current settings to Factory Default Settings. While the Device is

powered on, use a pin or paperclip to press and hold the Reset button

for more than 5 seconds, and then release the button. After that, the

Device will restart with factory defalut settings.

PAGE 1
DSL Modem SOHO Wireless Router WAN The WAN interface is connected to your Internet device, such as a cable or modem. LAN These interfaces provide a LAN connection to network devices, such as PCs or switches. USB Plug-in a USB storage for data sharing. TF Insert a TF card for data sharing. DC The DC interface is where you connect the provided power adapter. ON/OFF Reset Press this button to turn the Device on and off. Reset current settings to Factory Default Settings.
PAGE 2
www.uttlogin.com address field of your browser. Click “Yes to configure the router now”. http://www.uttlogin.com/-Microsoft Internet... www.uttlogin.com http://www.uttlogin.com/-Microsoft Internet... www.uttlogin.com Click “Start Control Panel Network and Connection Wireless Network Connection”, make sure wireless network connection is enabled. Click icon in the task bar. Please choose the wireless network you are going to connect in the pop-up list and click “Connect”.
PAGE 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.