Quick Start Guide

PSAM
SIM
Nano SIM
Micro SD
1
7
11
12
8
3
3
2
5
6
4
PSAM
PSAM
Nano SIM
Micro SD
9
10
Front Camera (Optional)
Power Button
Short press: Turn on/lock the screen.
Long press: When the device is off, press for 2-3 seconds
to start the device.
When the device is on, press for 2-3 seconds
to shut the device down or restart the device.
When the system crashes, press for 11 seconds
to restart the device.
Scan Button
Short press the button to enable scanning function.
Volume Button
Volume up/down.
Function Button
You can set a shortcut function.
Barcode Scanner (Optional)
For data collection through scanning.
Caution: Bright light. Do not stare into beam.
Rear Camera
For photo taking and 1D/2D barcode scanning.
SIM Card Slot/PSAM Card Slot (Optional)
You can insert a SIM card and a PSAM card.
Micro SD Card Slot/Nano SIM Card Slot
You can insert a Micro SD card and a Nano SIM card.
Dual PSAM Card Slot (Optional)
You can insert PSAM cards.
PIN for Extension (Optional)
It can be used to connect a handheld barcode scanner,
an UHF RFID reader, or an accessory for ETC or
temperature measurement.
Back Cover Lock
Lift the knob and rotate it to open the battery cover.
Note: The battery cover should be installed on the device,
otherwise it will affect normal use.
1
2
3
4
5
6
7
8
9
10
Quick Start Guide
11
12
Table for Names and Content Identification of Toxic and
Hazardous Substances in this Product
indicates that the content of the toxic and hazardous substance
in all homogeneous materials of the component is below the limit
specified in SJ/T 11363-2006.
indicates that the content of the toxic and hazardous substance
in at least one homogeneous material of the component exceeds
the limit stipulated in SJ/T 11363-2006. However, as for the reason,
because there is no mature and replaceable technology in the
industry at present.
：
：
The products that have reached or exceeded environmental protection
service life should be recycled and reused according to the Regulations
on Control and Management of Electronic Information Products, and
should not be discarded randomly.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FC
C Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
Part Name
Toxic or Hazardous Substances and Elements
Pb Hg Cd
Cr(VI)
PBB PBDE
Circuit Board Component
Structural Component
DEHP DBP BBP DIBP
Packaging Component
Notices
Note : This equipment has been tested
and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates,uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Manufacture
Shanghai Sunmi Technology Co., Ltd.
Room 605, Block 7, KIC Plaza, No.388 Song Hu Road, Yang
Pu District, Shanghai 200433 China
Safety Warning
· Connect the AC plug to the AC socket corresponding to the
marked input of the power adapter;
To avoid injury, unauthorized persons shall not open the
power adapter;
·
This is a Class B product. This product may cause radio
interference in living environments.
In that case, the user may be required to take adequate
measures against interference.
· Battery replacement:
1.Explosion danger may arise if replacing with the wrong
battery!
2.The replaced battery shall be disposed of by maintenance
personnel, and please do not throw it into fire!
Significant Safety Instructions
· Do not install or use the device during lightning storms to
avoid the potential risks of lightning shock;
· Please turn off the power immediately if you notice
abnormal odor, heat or smoke;
Suggestions
· Do not use the terminal near water or moisture to prevent
liquid from falling into the terminal;
· Do not use the terminal in extremely cold or hot environments,
such as near flames or lit cigarettes;
· Do not drop, throw or bend the device;
· Use the terminal in a clean and dust-free environment if
possible to prevent small items from falling into the terminal;
· Please do not use the terminal near medical equipment
without permission.
Statements
The Company does not assume responsibilities for the
following actions:
· Damages caused by use and maintenance without complying
with the conditions specified in this guide;
· The Company will not assume any responsibilities for the
damages or problems caused by optional items or consumables
(rather than the initial products or approved products of
the Company). The customer is not entitled to change or
modify the product without our consent.
· The product’s operating system supports official system updates,
but if you change the operating system into a third party
ROM system or alter the system files by system cracking,
it may cause system instability and security risks and threats.
Disclaimer
As a result of product upgrading, some details in this document
may not match the product, and the actual product shall
prevail. The Company reserves the right of interpretation
of this document. The Company also reserves the right to alter
this document without prior notice.
QUICK START GUIDE
T8910
B
M05052038
Handheld Wireless Terminal