Number pad d Fingerprint Standard Fin ngerprint High Securiity Fingerprin nt Rea ader Networrk Versio on Standalone Vers sion Can use Configuration C n Card to cha ange Enable usa age of a Fu unction Card d to Fingerprin nt Scanner to o Enrollment Device perform offline enrollme ent Fin nger Templa ate Storage Store in Fingerprint Sccanner Store in Miffare Card Fin ngerprint Ca apacity Support 2,000 users, Based on th he card capa acity of the maximum 4,000 templlates Access Con ntrol System
FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Model Functions Standard Fingerprint Reader Keypad Fingerprint Reader Configurable Functions Re-configure Window 5 seconds (Default) or Half an hour after Power up Reader Output Format CSN/UID 32bits, 34bits, 56bits (backward/forward), file content reading for programmed ID Wiegand Pulse Width Different choices to fit with different Controller’s requirements Keypad Output Buzzer Control LED/Back lit Control N/A Definable Reader & Controller control (Default) or Controller control only Define dif
Fingerprint Reader Installation and Operation Manual Fingerprint Reader Package Network Mode 1. Fingerprint Reader X 1 1) Max. supported 2000 user, 2 FP template for 1 user. 2. Stainless Steel screw M4 X 25 X 2 2) Configure Enrollment mode:normal reader;enroll device。 3) Configure access mode: Card + FP;Card only;FP only;Card or FP; 4) Supported Mifare, 125khz Prox and EM technologies. 5) Supported Mifare configuration card: Specification 1. Operating Voltage(V):5~16V DC 2.
Fig. 1 Fig.
Wiring COM_485B 485B Output to PC(Network Mode) SPK_IN Speaker Input RLED_IN Red LED Input GLED_IN Green LED Input N/A D_BELL Door Bell Output TAMPER Tamper Output System Connection Map Operation +12V +12V Prepare Items: GND 0V FP Enrollment Software D0/R_485A Weigand D0/RS232/485A Output 1 pc of Enrollment Device D1/R_485B Weigand D1/RS232/485B Output 1 or more than 1 pc of FP reader COM_485A 485A Output to PC(Network Mode) User Card RS485 to USB Converto
1. Collect user FP (2 Fingerprint templates) and user card details to FP Enrollment Software Data Base via Enrollment device. 2. Download the user data from software to device. FP Software 3. 1. Enroll the user information via “User Management” interface of Enrollment Software. a) “Read Card”: Present card to get the card information; or enter direct Download the user information from main interface of FP software to FP reader. a) “Query Device”: Check the online status of every device.
Card Reading Card only Read card success FP only Waiting for FP scanning FP reader able to set either of 4 types of access mode. They are Card only;Card + FP; FP only;Card or FP.
(50ms/time) Card and FP Read card success Orange LED light up,buzzer long beep once(100ms) Waiting for FP scanning Compare FP success FP Scanner blue LED light up Compare FP fail Orange LED light up,buzzer long beep once(100ms);Blue backlit light up for 5s。 Output card data Buzzer short beep (50ms/time) twice