User's Manual

User manual

Product Name: Remote Control Model：GDR-39

This transmitter works for both 9 and 12 dip switch receivers.

1. Using your original transmitter remove the panel to identify the switch

pattern. You can also match the switch pattern to the back of the operator

hanging in your garage.

Remove the programming panel from your new transmitter.

3. Using a small tip tool (such as ballpoint pen) match the switch pattern to your

new transmitter.

- If your transmitter/operator has 9 switches ,from left to right, set the first 9 using

the switch pattern and the last 3 to the OFF position

4. Replace the programming panel and test operation. Repeat these steps for any

additional transmitters.

PAGE 1
User manual Product Name: Remote Control Model：GDR-39 This transmitter works for both 9 and 12 dip switch receivers. 1. Using your original transmitter remove the panel to identify the switch pattern. You can also match the switch pattern to the back of the operator hanging in your garage. 2. Remove the programming panel from your new transmitter. 3. Using a small tip tool (such as ballpoint pen) match the switch pattern to your new transmitter.
PAGE 2
FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.