User Instructions

INSTRUCTIONS TO PROGRAM A REMOTE FROM AN EXISTING REMOTE:

1. Remove the panel on your existing remote to expose the dip switches.

2. M

atch the sequence from your existing remote to the new remote.

INSTRUCTIONS TO PROGRAM A REMOTE WITH NO EXISTING REMOTES:

1. Remove the panel on your existing remote to expose the dip switches.

2. Set a unique code using the 9 dip switches available. TIP: Do not use an easy to guess combination IE

repeating numbers

3. Some openers use a learn button to program a new remote while others use a dip switch system. Refer the

instructions on the back of your opener to pair the remote. Dip switch programming is done by setting the

same code on the receiver and remote. Learn button programming is usually done by pressing the lear

button then pressing any button on the remote to pair it. Lastly, some openers use the ON/OFF switch to

program a new remote.

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.