User Instructions

Press and release the learn button on the back of the motor unit. The light will illuminate for

30 seconds. This indicates the unit is in programming mode.

GD-R27

INSTRUCTIONS TO PROGRAM A REMOTE:

2. Within 15 seconds press the button you wish to program on the remote control.

You will hear an audible click and/or the light on the motor unit will turn off indicating the

remote successful programming.

*Repeat steps 1-3 for any additional remotes you wish to program. Wait 60 seconds befor

programming another remote control.

INSTRUCTIONS TO ERASE ALL CODES FROM MEMORY:

Press and hold the purple learn button the back of the motor unit for 6 seconds or until

the light turns off.

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.