Programming Instructions

KEYPAD PROGRAMMING INSTRUCTIONS

PRESS THE OPERATOR’S PRESS THE OPERATOR’S

LEARN BUTTON FOR 15 SECONDS

NOTE: PRESSING THE LEARN BUTTON FOR

MORE THAN 10 SECONDS WILL ERASE ALL

KEYPAD CODES AND REMOTE CONTROLS

WHILE THE LEARN OPERATOR LIGHTS

LIGHT IS ON, ENTER FLASH WHEN THE

A 1-6 DIGIT KEYPAD KEYPAD CODE IS

CODE AND PRESS ACCEPTED

THE KEYPAD’S

START/STOP KEY

REPEAT STEPS 1 & 2

FOR ANY ADDITIONAL

KEYPAD CODES

PAGE 1
KEYPAD PROGRAMMING INSTRUCTIONS PRESS THE OPERATOR’S LEARN BUTTON PRESS THE OPERATOR’S FOR 15 SECONDS NOTE: PRESSING THE LEARN BUTTON FOR MORE THAN 10 SECONDS WILL ERASE ALL KEYPAD CODES AND REMOTE CONTROLS WHILE THE LEARN LIGHT IS ON, ENTER A 1-6 DIGIT KEYPAD CODE AND PRESS THE KEYPAD’S START/STOP KEY REPEAT STEPS 1 & 2 FOR ANY ADDITIONAL KEYPAD CODES OPERATOR LIGHTS FLASH WHEN THE KEYPAD CODE IS ACCEPTED
PAGE 2
Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.