Users Manual

SettingPINonKeypad:

1. Confirmthatthekeypadbacklightisoff(donotpressanybuttons)

2. Press357onthekeypadthenpressthePROGRAMbutton

3. LEDwillblink,nowenteraunique3‐8digitPINnumber

4. PressthePROGRAMbutton

5. Thekeypadwillblinktwiceandshutoffconfirmingsuccessfulprogramming

KeypadtoOpenerProgramming:

1. Enterprogrammingmodeonyourgaragedooropener(usethestepsbelow)

2. Confirmthatthekeypadbacklightisoff(donotpressanybuttons)

3. EnteryourPIN(fromabove)intothekeypad

4. PresstheUPorDownkeyontheopener3‐4timesuntilitoperatestoconfirmsuccessfulprogramming



OpenerProgrammingModeOption1

A)PressandholdtheprogrambuttonasshownbelowuntiltheLEDbuttonilluminates,thenrelease

B)TheroundLEDwillturnoffandthelongLEDwillbeginflashing

C)Returntostep2inKeypadtoOpenerProgrammingabove



OpenerProgrammingModeOption2

A)Pressthenreleasethelearncodebutton

B)TheLEDwillflashindicatingprogrammingmode(30seconds)

C)Returntostep2inKeypadtoOpenerProgrammingabove



PAGE 1
Setting PIN on Keypad: 1. 2. 3. 4. 5. Confirm that the keypad backlight is off (do not press any buttons) Press 3 5 7 on the keypad then press the PROGRAM button LED will blink, now enter a unique 3‐8 digit PIN number Press the PROGRAM button The keypad will blink twice and shut off confirming successful programming Keypad to Opener Programming: 1. 2. 3. 4.
PAGE 2
PAGE 3
FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.