User's Manual

ManualsBrandsShanghai Senben Lighting Technology ManualsElectronicsFACTORY LAMP

User manual

FCC ID: 2AA551106610665

For Model: SBD1106-YQL65;

SBF6106-YQL65;

1. use

Shanghai Senben Lighting Technology Incorporated Company’s SBD1106 SBF6106 Maintenance-free,

Energy-saving,Waterproof, Dustproof and Corrosion-proof Factory Lamp, the light source is induction lamp, and

has the high Luminous Efficiency, longer lifespan etc features, the luminaire adopts the integrated structure,

aluminum alloy die-casted ballast box and incoming line cover with the surface painted with polyester powder,

This product is applicable for the common lighting or emergency lighting of such indoor and outdoor place with

mech dust or damp such as factory ,airport,tunnel,especially power plant and its boiler unit,iron& steel plant and

so on.

2.Electrical parameters:

1. Rated Vol.:120VAC 60Hz

2. Illuminant: Electromagnetic

induction illuminant

3. Power: 65w or 80w

4. Ex marking:

Ex deⅡCT4 Gb (65W)

Ex deⅡCT3 Gb (80W)

DIP A20 TA, T6

5. IP code: IP66

6. Corrosion-proof grade: WF2

7. Applicable cable outer diameter:

φ 9～12.5mm

8. Outline and installation size see Figure 1

3. Directions

1. In order to ensure the safety service of this Ex light, it shall be installed and maintained by trained

personnel. Unauthorized people shall not open or disassembly the fasteners.

2. Since polyester transparent cover is adopted, there is a waning label: Warning - Potential electrostatic

charge - see Instruction Manual. The installation hight shall no less than 2.5m, user shall pay

attention to the electrostatic charge. Avoid ignition risks caused by normal service, maintenance and

cleaning; do not touch or wipe the light in hazardous areas. Necessary replacement, wiping and touch

shall be carried out in non-hazardous area.

3. Installation and maintenance procedures shall meet associate national standards, do not operate when

energized. Do not open when energized in maintenance or replacement and waiting for the illuminant

to cooldown.

4. There must be a designated person to in charge of the maintenance work specially.

a) Special operational platform, ladder, safety belt and other necessary equipment shall be

equipped to ensure personnel safety;

b) Inspect the light periodically, any component damage, loss shall be fixed in time; replace the

aged sealing ring or other plastic part to ensure the explosion proof performance.

Figure1

Picture 1

Type A

Type D

Summary of content (3 pages)

PAGE 1
User manual FCC ID: 2AA551106610665 For Model: SBD1106-YQL65; SBF6106-YQL65; 1.
PAGE 2
5. 6. Take care of the disassembled components to avoid loss or drop from high cause casualties. Aged sealing rings shall be replaced by one of the same specifications to ensure the explosion proof performance. See Figure 12 for the detailed specifications. 7. Ensure Do not open when energized is strictly followed, cut off the power if the top cover is required to open in maintenance. The internal and external earthing shall be reliable. Unauthorized personnel is not allowed to disassemble the light.
PAGE 3
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna.