User's Manual

GM01 USER MANUAL

1. Overview

Figure 1 shows an overview of the position of the ports and interfaces on the GM01.

2. Prod

uct interface instruction

1) IMB interface: The IMB interface connector utilizes the interface between the GM01 and the

hosting projector and is compliant to the following specifications from Texas Instruments (TI):

All three OEM partner of TI (Barco, Christie, NEC) have implemented this interface within their

respective Series 2 projector series.

) LTC IN/LTC OUT: The LTC IN/OUT interface used to Longitudinal Time Code in / out function.

And it can be configured as multi- GM01 sync function.

3) 2 3G-SDI IN: Those interfaces have no function current, just reserved for later.

4) Audio OUT: AES digital audio output interface belonging to GM01 with AES digital audio input

interface belonging to digital audio processor using audio wire, then it can transmit the decoded

PAGE 1
GM01 USER MANUAL 1. Overview Figure 1 shows an overview of the position of the ports and interfaces on the GM01. 2. Product interface instruction 1) IMB interface: The IMB interface connector utilizes the interface between the GM01 and the hosting projector and is compliant to the following specifications from Texas Instruments (TI): All three OEM partner of TI (Barco, Christie, NEC) have implemented this interface within their respective Series 2 projector series.
PAGE 2
voice to audio processor to achieve the original state of cinema voice. 5) LED: The LED is state indicator, every LED reflect the GM01 internal states. It is used to diagnose and analysis the situation of GM01. 3. Operation Procedures 1) Connecting keyboard and mouse with USB port from the front panel of this device, and connect the monitor (with HDMI interface) with HDMI output interface from front panel of this device using HDMI cable.
PAGE 3
interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.