User's Manual

ManualsBrandsSHANGHAI MERIT TECHNOLOGY ManualsElectronics2.4GHz RADIO SYSTEM

Table Of Contents

LED Indicator

SAIL TRIM

SAIL

STICK

Power down mode

( PDM ) BUTTON

ANTENNA

RUDDER

STICK

RUDDER

TRIM

SERVO REVERSE SWITCHES

MERMAID

MERMAID Instruction Manual

2CH 2.4GHz RADIO SYSTEM INSTRUCTION (T2HF)

LED INDICATOR LIGHTS

Two LEDs display to indicate the battery voltage level, power down mode and ID

set up function.

SERVO REVERSE SWITCHES

Servo reverse switches reverse the direction of the operation of the servos. The lower

position is normal and upper position is reverse.

CHANNELS:

CH1: Rudder

CH2: Sail

REAR PANNEL

The transmitter needs 8 AA batteries (sold separately). To open the battery

compartment slide the cover down while pressing the part marked:

PUSH

Summary of content (6 pages)

PAGE 1
MERMAID 2CH 2.4GHz RADIO SYSTEM INSTRUCTION (T2HF) ANTENNA LED Indicator SAIL TRIM RUDDER STICK SAIL STICK RUDDER TRIM Power down mode ( PDM ) BUTTON SERVO REVERSE SWITCHES LED INDICATOR LIGHTS Two LEDs display to indicate the battery voltage level, power down mode and ID set up function. SERVO REVERSE SWITCHES Servo reverse switches reverse the direction of the operation of the servos. The lower position is normal and upper position is reverse.
PAGE 2
MERMAID CONNECTIONS Connection example is shown below. Connection Example LED Rudder Servo (CH1) Receiver R601SF Sail Servo (CH2) Receiver Switch * Insert four batteries. Receiver battery holder 2.4GHZ FHSS RADIO SYSTEM SETUP 2.4GHz systems have different characteristics than that of the conventional frequencies therefore ,please read the section carefully to enjoy safe sailing with the 2.4GHz systems.
PAGE 3
MERMAID RECEIVER ANTENNA INSTALLATION The receiver has one antenna. Lay & tape the antenna on the hatch seal as shown . 1. The antenna must be kept away from conductive material ,such as material and carbon by at least half an inch. The coaxial part of the antenna does not need to follow these guidelines ,but don't bend it in a small radius. 2. Keep the antenna away from any noise sources as much as possible. 3. Cover the hatch cover with rubber band.
PAGE 4
MERMAID 1. Place the transmitter and receiver close to each other (with 1 meter). 2. Turn on the transmitter then the receiver. If they are not paired, the read LED on the receiver will blink slowly or be off, follow the next steps to link and pair the receiver and the transmitter. 3. Press the transmitter “PDM” switch, the two LEDs blink alternately, then releaset the switch.
PAGE 5
MERMAID Federal Communications Commission (FCC) Statement This equipment has been tested. And it found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and uses and radiates radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.
PAGE 6
1058 Taogan Road, Sheshan, Songjiang district, Shanghai, China 201602 Tel: 86-21-57793858