Quadcopter Operation Manual ! IMPORTANT : Radio controlled model NOT A TOY ! ● This high performance model must be assembled and operated according to the instructions. ● May cause serious injury to persons or property if not used responsibly. ● Unsuitable for children under 18 years old.
Index What’s included?................................................................................3 Basic Function Introduction..........................................................3 The Remote Control.........................................................................7 Function Description........................................................................8 How to achieve the maximum distance?..................................9 The Quadcopter................................................
What’s Included? Package Contents: 1. Assembled Quadcopter 2. 8 Channel 2.4GHz Remote Control 3. DC-DC Charger (may change or remove depended on final configuration for different regions) 4. AC-DC Adaptor (may change or remove depended on final configuration for different regions) 5. 5200Ah 4S LiPo Battery (may change or remove depended on final configuration for different regions) 6. Telemetry Kit 7. OTG Cable 8. Operation Manual.
■ GPS hold - When GPS is located, this function will hold the Quadcopter where it is. When “GPS hold” is turned on, the Quadcopter can’t takeoff if the GPS signal is too weak. ( Suggest: the wind speed shall be under 4~5 level or lower than 15km/hr ) ■ Attitude hold – The Quadcopter will hold the altitude & keep stabilized automatically while not getting any control input from the pilot or fail safe action. Note: the Quadcopter may slight shift in the air by wind or any un-notable foreign force on it.
● There is a flat platform on the rear and bottom of the airframe, the optional devices could be attached to the Quad-copter easily. ( Optional modules: FPV + gimbal module, offload hook, spot light… etc) ● There are plug pins under & above the Quad-copter, which are for connecting to the Camera gimbal controls, Video in/out, external servos, OSD unit, Video remote control….etc, no modification needed, just plug & play.
● Here are other port extensions : Upper port extensions Lower port extensions ★★★ ▲▲▲ 1. ▲▲▲: video signal / ★★★ : audio signal 2. CH7: external module control port, connecting to the top right knob on remote control. 3. CH8: external module control port, connecting to the top left knob on remote control. 4. CH9&CH10: default no function. 5. DATA IN&DATA OUT: for connecting OSD system. P.
The Remote Control : Function Description : LED indicator Green & Red CH.8 Knob CH.7- Knob CH.6- Orientation Attitude mode switch CH.5- Flight mode switch Joystick 2 & Digital trims Bind switch Joystick 1 & Digital trims Stick mode switch P.
Function Description : 1. Specification: ● Output: <100mW, Meet the FCC, CE, Telec, NCC regulations. ● Control range: 1000 Meters. ● Power source: “AA” (UM3) alkaline battery x 4 pieces. 2. Joystick 1 (at right side): ● Stick Mode 1: Roll, Altitude control. ● Stick Mode 2: Roll, Pitch control 3. Joystick 2 (at left side): ● Stick Mode 1: Yaw, Pitch control ● Stick Mode 2: Yaw, Altitude control. P.
4. CH. 5 - Flight mode switch: ● Up: GPS Hold ● Middle: Altitude Hold ● Down: Return to “Launch point” 6. CH.7 & 8 Knobs: Control the RC devices connected to CH.7 & 8 port extension at the The Quad-copter bottom. 7. Stick mode switch: Select stick mode 1 or mode 2. 8. Bind switch: Trigger binding function with other multi-copter. 9. Main power switch: ● Up: Turn on the remote control. ● Down: Turn off the remote control. 10. LED indicator Green: Bind 11. LED indicator RED: Power 12.
The Quad-copter : The Quad-copter Specifications : ● Carry & storage dimensions: 215mm x 215mm x H 195mm. ● Ready to fly dimensions (Propeller folded): 609.0mm x 609mm x H 195.0mm ● Ready to fly dimensions (11 in. Propeller extended): 842.0mm x 842.0mm x H 195.0mm ● Maximum motor to motor dimension: Ø 567.0mm ● Motor: 2826 size 920KV. (Various motors are available as option for higher payload.) ● Empty RTF weight: 985g (Fully assembled, battery not attached.
P.
Un-fold the Quad-copter : ● Rotate two front arms forward till the end. ● Rotate the two rear arms backward till the end. ● Flip the two landing gear downward. ● Fix the landing gear by the support hook or the velcro strap. ● Unfold the propellers. (Note: if the propellers are not unfolded completely, it may cause strong vibration and lead the take-off to failure.) P.
Fold the Quad-copter : ● Reverse the process of "unfold the Quad-copter". ● Use one hand to hold the main body, the other hand to “PUSH” the arm inward to the main body. Never hold single arm while carrying the Quad-copter. Charging the Battery : The following descriptions vary according to different accessories. ● Connect the included balance charger to a power adapter. ● Insert the smaller connector into the charger. Check the connector pin is inserted properly.
Battery Storage : ● Never store fully charged battery for over two days. Storing fully charged battery overtime may cause damage to the cell and decrease the flight time. ● Make sure that the battery is kept in a cool and dry storage. ● Stabbing or disposing battery may cause fire. Flight : Install the Battery Pack ● Whatever the payload (Battery, Camera, … etc, anything except the Quad-copter itself.
Motor disarming : ● When the Quad-copter finish landing, move the throttle stick in low position. Make sure the motors are spinning in slow speed; or the Quad-copter will rotate quickly. MODEL 1 MODEL 2 MOTOR DISARM ● Pull the joysticks as the picture above and stay 2 seconds -the blue LED on the right corner of the Quad-copter will flash once. ● Pull the joysticks till the motor is fully stopped. The motor disarming is completed. GPS Hold : ● In GPS located situation, GPS-Hold (CH.
Return to “Launch point” ● When the motors are armed in GPS located situation, the “launch point” coordinate will be saved in The Quad-copter. ● Whatever how the RTL function is activated, by the flight mode switch (CH.5 at low position)” or because the failsafe, the Quad-copter will keep at least a 15M or higher altitude then fly back to the launch point and land. ● In failsafe RTL, the flight mode can be changed anytime when the CH.5 switch is flipped to other flight mode.
Intelligent Attitude Mode : ● Usually, intelligent attitude mode is activated when the Quad-copter flies beyond visual range. ● When the intelligent attitude mode is activated by CH.6, it uses the vehicle’s position relative to home instead of the vehicle’s initial heading when it was armed. This means no matter where the vehicle is, pulling the pitch back will cause it to return towards home regardless of the vehicle’s actual heading.
● We suggest pilot to activate ALT-Hold (CH.5 at middle position) and land manually. ● Please reserve about 30% power for return and landing. Do not use the low battery fail safe as a flight time alarm – it will decrease the battery using time; there is risk that the Quad-copter couldn’t make it to launch point. DISCLAIMER & WARNING : ● Please read this disclaimer carefully before using this product. This product is not suitable for people under age of 18.
2. This product features a built-in autopilot system and we have made its operation as safe as possible. However, it is good practice to remove all propellers before switching it on to for calibration and parameter setting. 3. Be sure to check all connections and keep children and animals a safe distance away during firmware upgrades, system calibration and parameter setting. CAUTIONS : Carry out each of the following steps carefully before before every flight. 1. Fly safe.
USING BATTERY : 1. Do not soak the battery. Make sure that the battery is kept in a cool and dry storage. 2. Do not mix-use flight battery and single-use battery. Do not mix battery brands inside the controller. 3. Keep battery out of the reach of children. If a child swallowed the battery accidently, ask for medical help as soon as possible. 4. Do not charge battery near flammable materials or on a flammable surfaces such as carpet or wood 5. Always use a KP FUN INC approved adapter. 6.
1. Damage(s), injuries or any legal responsibilities incurred when users are drunk, taking drugs, under the influence of anesthesia, dizziness, fatigue, nausea and any other conditions both physical and mental that could impair your ability 2. Damage(s), injuries or any legal responsibilities caused by subjective intentional operations. 3. Any mental damage compensation caused by accident. 4. Damage(s), injuries or any legal responsibilities caused by flying in no-fly zones such as natural reserve. 5.
FCC This device was tested for RF exposure in an uncontrolled environment, the measured Body SAR value is 0.071 W/kg.
