2.4GHz FHSS Digital RC System MT-203 in 1 MT-203 MR-203 3.7V PP / î PP : î PP + Switch to control LED on/off.
.4GHz FHSS Digital RC System CH3 Wheel (CH1) Reverse CH1 Throttle Steering Dual Throttel Coutrol Switch Rate Knob ( D/R) CH1 Steering Trim Power/Bind Bind Indicator Button Power Switch %UDNH 21 2)) %DFNZDUG /(' %UDNH /(' &+ &+ &+ 6 5 4 3 2 1 Antenna Wire Receiver Motor Power Swith Battery 2 /(' %UDNH /(' %DFNZDUG /(' %UDNH 21 2))
2.
2.4GHz FHSS Digital RC System knob Steering Trim Knob THROTTLE CONTROL SWITCH Low,Middle,High speed selection. To set throttle control rate by adjusting the switch to high,middle and low rate per your selection. Throttle Trim Knob L M H + adjusting adjusting Bind MR-203 Press the Bind button and power on the transmitter LED on transmitter will flashing.
2.4GHz FHSS Digital RC System Warning words FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation.