User's Manual

Steering Dual Rate

Lever (D/R)

Steering Trim

Lerer (CH1)

Connects to the steering servo

Motor connector

Battery connector

Power switch

CONNECTION

MT-202

227g

Operating

6.0~8.4V(Ni-cd)

Antenna (Built in)

6.0~7.4V(Li-poly 2s)

0.26oz (7.4g)

MR-202

PAGE 1
MT-202 MT-202 MR-202 RF Operating 6.0~8.4V(Ni-cd) 6.0~7.4V(Li-poly 2s) 8 0.26oz (7.
PAGE 2
MT-202： 1.CH1(Steering) Trim： Steering neutral adjustments can be made by moving the steering trim lever to the left or right. When you install a servo, always check to be sure the servo is at its neutral position. Adjust the servo horn position and linkage so both are parallel. Be sure the steering trim on the transmitter is at the neutral position. 2.CH1(Steering Dual-Rate)D/R： Use this function to adjust the steering travel of your model.
PAGE 3
FCC Information and Copyright This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.