Quick Start Guide

ManualsBrandsShanghai Kungye ManualsElectronicsSHIELD Sensing Controller

SHIELD: Quick Start Guide

Hardware overview

System LED

Functions

Description

Battery power indicator

Green – near full power

Yellow – mid battery

Red – low battery

Red fast flash – almost run out of battery

Flash slowly -- charging

Bluetooth connection

Blue steady (taillight only)

System status

Blue flash – pairing

Blue fast flash – transferring data

Functions of button

Functions

Description

1 click

Check battery capacity

3 clicks (Controller only)

Enable find-my-bike of taillight

Long press 3 seconds

Enter device pairing mode

Long press 10 seconds

Restart device

Disarming tap code (taillight only)

Double click enable tap code, which consists 5

short- or long-press combination

Summary of content (7 pages)

PAGE 1
SHIELD: Quick Start Guide Hardware overview System LED Functions Battery power indicator Bluetooth connection System status Functions of button Functions 1 click 3 clicks (Controller only) Long press 3 seconds Long press 10 seconds Disarming tap code (taillight only) Description Green – near full power Yellow – mid battery Red – low battery Red fast flash – almost run out of battery Flash slowly -- charging Blue steady (taillight only) Blue flash – pairing Blue fast flash – transferring data Descriptio
PAGE 2
Things in the box Taillight Light mount Seat post fixture Multifunctional Controller Zip tie Large screw Small screws L wrench Silicone ring Taillight release tool Silicone band Activate your device The devices shipping to you were set to shipping mode. To activate your device, you must connect devices to a 5V power through USB cable. Then, pair your devices with APP to complete activation and use all functions. Download APP For Android phone https://www.pgyer.
PAGE 3
Install your SHIELD Install your controller of SHIELD to your helmet - To size adjustment wheel Use a silicone ring to fix your controller on size adjustment wheel of your helmet. Be sure that direction of controller’s USB must face bottom right and white cover must face backward.
PAGE 4
Install your taillight to your bike Silicone band Large screw Small screw Release your taillight from mount Push the release tool into the side hole and then push taillight out of the mount.
PAGE 5
Main functions 1. Automated turn and brake signal SHIELD by EESENS is the first bike taillight equipped with this “automatic turning signals” function. Our patented sensor algorithm in the controller detects your gesture of “shoulder check” correctly by the motion of your head. When your head turns to check the traffic behind you, the controller on your helmet will check your turning angle, speed and hold time. If these factors meet the criteria, the controller will trigger the turn light.
PAGE 6
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 7
cet appareil est conforme à l'exemption des limites d'évaluation courante dans la section 2.5 du cnr - 102 et conformité avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des données canadiennes sur l'exposition aux champs rf et la conformité. This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.