User's Manual

Table Of Contents

Quick Use Notice

Please Read Before Installation

FCC’s Authentication Announcements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation.

This equipment has been tested and complies with the limits for a Class B digital device, pertaining to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment.

This equipment can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference will occur in a

particular installation. You can test whether this equipment does cause harmful interference to radio or television reception

by turning the equipment off or on.

OPERATION MANUAL OF EXTREME DUTY TPMS SENSOR

· Handling of tires and rims should be carried out only by workers who have

received training and accreditation based on instruction from a qualified work

supervisor.

· Check the “Tire and Rim Handling Manual” published by the tire manufacturer

for information on work and inspections, etc. involving tire handling.

· When lifting heavy components or equipment, make sure that you use suitable

lifting equipment and that you follow the instructions in the manual for

equipment to be used.

· When moving tires and rims, be careful to avoid accidental drops or falls that

could injure others in the vicinity.

· There are several types of tools for work involving tire and rim handling. Be

sure you have proper understanding of how the tools are used and carry out the

work in accordance with proper procedures.

· Be sure to perform a visual examination of tires and rims when conducting

regular inspections of vehicles and tires or tire rotations.

· Use tires and rims suited to the vehicle, as specified by the vehicle

manufacturer and tire manufacturer.

· In the case of dual assemblies, DO NOT operate the vehicle on a single tire as

the load capacity of the tire and rim will be drastically reduced and may result in

damage

PAGE 1
OPERATION MANUAL OF EXTREME DUTY TPMS SENSOR Quick Use Notice Please Read Before Installation · Handling of tires and rims should be carried out only by workers who have received training and accreditation based on instruction from a qualified work supervisor. · Check the “Tire and Rim Handling Manual” published by the tire manufacturer for information on work and inspections, etc. involving tire handling.
PAGE 2
INSTALLATION GUIDE Mounting CV TPMS Sensor Before installation, identify each pair of transmitter and ID module. There are two labels coming with each pair of transmitter & ID module, and they have the same ID code. For example: 01EB327F. A Install the transmitter onto the wheel and place the rim label on the rim. Plug ID Module into Display (Refer to Operation of Display) 1. Loosen the steel strap. Wrap the strap around the centre of the rim in the lowest spot and mark it 5 cm (2”) past worm gear.