-800-568-9188 www.valortpms.com 4320 Harvester Rd.
SETUP GUIDE – TEMPTRAC 1. INTRODUCTION OF TEMPTRAC This Temptrac developed for refrigerated transport vehicles. It can send temperature data to the data receiver in time, so that customers can monitor the temperature in the refrigerator. It has the advantages of simple installation, high precision of temperature test and long service life.Temptrac is a new temperature transmitter based on evaluation of transmitter in truck series.
INSTALLATION GUIDE – TEMPTRAC Truck Diagram ZONE 1 Geotab GO Device ZONE 2 Transceiver Sensors Antenna There Are 2 Installation Steps For This Product: 2. TRUCK CAB INSTALLATION 3. REEFER UNIT INSTALLATION NOTE: The Transceiver needs to be installed near the GO7 Unit. NOTE: Turn on Sensors prior to installation (back of unit). Sensors are active once turned on. In humid environments or where sensor can get wet after turning on sensor, use dialectic silicon,or sealant on sensor power switch. 1.
SETUP GUIDE – TEMPTRAC FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harm ful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
SETUP GUIDE – TEMPTRAC ISED Statement ‐ English: This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES‐3 (B)/NMB‐3(B).