Operation Manual

ManualsBrandsSHANGHAI BAOLONG AUTOMOTIVE ManualsElectronicsTEMP-SENSOR

Table Of Contents

OPERATION MANUAL OF TEMP-SENSOR

MODEL:QY1026A0

Thank you for choosing our TEMP-SEMSOR. This guide instructs the technician how to

properly mount and dismount a Baolong TEMP-SEMSOR receiver.

Introduction of TEMP-SEMSOR

Truck Diagram:

There Are 2 Installation Steps For This Product:

1. TRUCK CAB INSTALLATION

NOTE: The Transceiver needs to be installed near the GO7 Unit.

1) Connect the supplied GO wire Harness to the Transceiver.

2) Connect the other end of the supplied Valor Wire Harness to the Geotab IOX-CAN

Harness.

3) The Geotab IOX-CAN Harness connects to the GO7 device.Connect to the vehicle

where indicated.

4) Data is communicated over the Geotab IOX-CAN.

5) Route the antenna to the rear of the cab and mount in a safe place away form step

and pinch points.

Summary of content (4 pages)

PAGE 1
OPERATION MANUAL OF TEMP-SENSOR MODEL:QY1026A0 Thank you for choosing our TEMP-SEMSOR. This guide instructs the technician how to properly mount and dismount a Baolong TEMP-SEMSOR receiver. Introduction of TEMP-SEMSOR Truck Diagram: There Are 2 Installation Steps For This Product: 1. TRUCK CAB INSTALLATION NOTE: The Transceiver needs to be installed near the GO7 Unit. 1) Connect the supplied GO wire Harness to the Transceiver.
PAGE 2
. REEFER UNIT INSTALLATION NOTE: Turn on Sensors prior t installation(back of unit). Sensors are active once turned on. In humid environments or where sensor can get wet after turning on sensor, use dialectic silicon, or sealant on sensor power switch. 6) There is a sensor for each zone and each sensor is assigned to a zone. The sensor for zone one is marked an such(Zone 1), while the sensor for zone two is unmarked. Each sensor has a unique identifier code which is pre-programmed into the Transceiver.
PAGE 3
Warnings FCC Requirement : （1）All products: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 4
(2) This device must accept any interference, including interference that may cause undesired operation of the device. L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.