User Manual

Sensor
Copper Foil
Sensor
Fax: [phone]
eMail: [e-mail]
Shadow Elektroakustik
Peter-Haendel Straße 2
91334 Hemhofen · Germany
Shadow Electronics of America Inc.
17791 Alexander Run
Jupiter, FL 33478 U.S.A.
Fax: +49 - 91 95 - 92 99 30
eMail: [e-mail]
Montageanleitung für Shadow SH SV1
Violin-Transducer
Inhalt:Inhalt:
Fig. 3Fig. 3
Fig. 1Fig. 1 Fig. 2Fig. 2
1. Test fit sensor into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1). Pickup can
also be mounted between the bridge feet and body (see Fig. 2).
1. Test fit sensor into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1). Pickup can
also be mounted between the bridge feet and body (see Fig. 2).
Note:
Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we
recommend an amplifier with low impedance input.
2. Install the sensors into the bridge slot.
3. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.
2. Install the sensors into the bridge slot.
3. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.
Installation into the slot between the wing and the foot.
If pickup is too loose, shim with included shim material (see Fig. 2). If pickup is too tight, file the bridge slot slightly.
Installation into the slot between the wing and the foot.
If pickup is too loose, shim with included shim material (see Fig. 2). If pickup is too tight, file the bridge slot slightly.
transducer disc (12mm diameter)
output socket (6,3mm) with Velcro
copper foil
transducer disc (12mm diameter)
output socket (6,3mm) with Velcro
copper foil