All Right Reserved Content List 1. Receiver... x1 2. Handheld Mic(Bodaypack) x2 3. Audio Cable 4, Charge Gable. 5 . x1 6. 185001 thrum Battery 1.8V AA Battery) 7. Manual Operating Manual UHF Digital Wireless Microphone Please read this manual carefully before use.
8. TECHNIQUE SPECIFICATION RECEIVER Carrier Frequency: UHF-980MHz Bandwidth: MHz Channel Bandwidth: 300KHz Preset Group: 15 group, 6 frequencies In each group. Dynamic Range: 96dB Distortion: <0.1% Frequency Response: Signal/Noise Ratio: 96dB Receiving Sensitivity: -DBMS Transmission Delay: <3ms Power Supply: DC12~18V 1A Audio Output: 1x 6.
3.PARTS (RECEIVER) 1. POWER SETUP A 3.IR 4. UNLOCK 5. TFT WINDOW 6.IR 7. TFT WINDOW 8.IR 8. UNLOCK 10. SETUP B 11.ANT-A 12,ANT-B 13.MIX.0UT 14.BALANCE A 15.BALANCE 8 16.DC INPUT 17.USB CHARGE OUTPUT Long press IR button, start sending signal while signal icon flashing, turn on handheld microphone, put the IR window against the Receiver IR window. Signal icon disappear when IR connected, frequency shows the same between handheld microphone and Receiver.
7. RECEIVER OPERATION @ Pull out the antenna (11), (12), make them to be perpendicular with the receiver. Connect the power: Connect the power cable to the DC socket (16) of the Receiver, make sure the adapter is suitable before using the Receiver. @ Connect the audio cable; Mix output: connect the audio cable (attached) to the MIX. OUT socket (13) while the other side connect to MIX. IN or AUX. IN socket of the mixer or amplifier.
Display function operation » When the receiver working, long press UNLOCK to UN-locked the system before setting. Initial setup from channel adjustment, below is the operation of the product. Note: the below setting is under unlock status, long press UNLOCK before setting. ® Channel setting model select menu icons numbers change Adjust SETUP control nab, and press it enter into the channel setting mode while GR/CH is flashing.
(3) Don't put the two microphone to use together: (4) Attention the using distance between the microphone Grille and mouth is less than 15cm. (5) Avoid pointing the Grille against the Horn. 6. BODY PACK OPERATION 1.MICROPHONE 2.INPUT SOCKET + 5.POWER 6. ANTENNA 7.LCD DISPLAY 8.IR SETTING SWITCH 9.BATTERY SINKIANG AA BATTERY ATTENTION WITH THE RIGHT POLARITY 10.BATTERY COVER * Scan available channel mode select menu icons Spectrum Analysis of Environmental 811.
5. HANDHELD MICROPHONE OPERATION Microphone capsule: use to pick up sound. 2. LCD display: indicates the microphone working information status. 3. SYNC window: use to receive IR signal, when SYNCING must put against to the Receiver IR window . 4, ON/OFF switch: control the handheld microphone of power on, mute and off. 5. Battery Sink: insert 1x18500 lithium battery, note to insert in correct polarity. 6. Mic cap: unscrew it when change battery. » HANDHELD MICROPHONE LCD FUNCTION 1.