Use and Care Manual

ManualsBrandsSeville Classics ManualsCloset Storage & Organization72 in. Bronze Expandable Closet Organizer

Customer Service Informaon

Telephone: (800) 323-5565

Fax: (310) 533-3899

Hours: 8:30 AM – 4:30 PM (PST)

Email: Support@SevilleClassics.com

Homepage: www.SevilleClassics.com

Specicaons

Dimensions: 58" W (expandable up to 83") x 14" D x 72" H

Weight capacity per shelf: 100 lbs.

Weight capacity per rod (extended): 125 lbs.

Weight capacity per rod (unextended): 50 lbs.

FAQs

Q: Can I use it with only one expandable rod?

A: Yes! The towers can stand on their own without either rod aached.

Q: How many shelves do I need to install?

A: You only need to install shelves at the boom and very top of each tower.

Q: Can I install the shelves in any order?

A: Yes! Customize the unit to t your storage needs. Make sure there is a top

and boom shelf for stability.

Expandable Closet Organizer System

Model #: SHE05813BZ, SHE05814B

Thank you for choosing Seville Classics! We hope that you enjoy your

commercial-grade steel wire shelving! Please read through this guide for

parts list, assembly instrucons, frequently asked quesons and further

contact informaon.

112019

Summary of content (4 pages)

PAGE 1
FAQs Q: Can I use it with only one expandable rod? A: Yes! The towers can stand on their own without either rod attached. Q: How many shelves do I need to install? Expandable Closet Organizer System A: You only need to install shelves at the bottom and very top of each tower. Q: Can I install the shelves in any order? A: Yes! Customize the unit to fit your storage needs. Make sure there is a top and bottom shelf for stability.
PAGE 2
Parts List Wall Strap Installation Please make sure you have all the parts on this list. IMPORTANT Installing wall straps is not necessary, but it is highly recommended. A. Bottom poles (8) H. U-clips (4) (Threaded end) B. Top poles (8) (Plastic cap on end) I. Screws (4) C. Slip sleeves (48) J. Feet (8) D. Shelves (8) K. Liners (8) E. Top shelves (2) STEP 1. Loop the NYLON STRAPS (L) around the side of top-shelf nearest to the wall. Use 1 per tower. STEP 2.
PAGE 3
STEP 7. Clip U-CLIP (H) over BRACKETS (F). Assembly Instructions STEP 1. TIP! Adjust the depth of the U-CLIPS (H) to offset the rods for more hanging space. Screw LEVELING FEET (J) into base of bottom poles. Snap SLIP SLEEVES (C) around the grooves on BOTTOM POLES (A) for your lowest shelf. Attach the small end of EXPANDABLE ROD (G) to U-CLIP (H) with SCREWS (I). Attach large end to other tower. TIP! Perform each step for both towers at the same time. STEP 2.
PAGE 4
STEP 3. STEP 5. Decide on the height for your bottom ROD BRACKET (F). Decide on the height for your top ROD BRACKET (F). IMPORTANT! Test the height with clothes on hangers to confirm you have enough space when you install the EXPANDABLE ROD (G). IMPORTANT! Test the height with clothes on hangers to confirm you have enough space when you install the EXPANDABLE ROD (G). Fit SLIP SLEEVES (C) around two poles on the same side. Fit SLIP SLEEVES (C) around two poles on the same side.