Use and Care Manual

ManualsBrandsSERENE VALLEY ManualsBath32 in. Wall-Mount Bathroom Solid Surface Vanity with Special Storage Area in Matte Gray

INSTALLATION MANUAL

www.serenevalleydesign.com

Dual-mount Bathroom

Sinks Installation Manual

SVWS601, SVWS602, SSVWS603L, SVWS604, SVWS605, SVWS606, SVWS607,

SVWS608, SVWS609, SVWS610, SVWS611, SVWS612, SVWS613, SVWS614,

SVWS615

Summary of content (8 pages)

PAGE 1
INS T AL L AT I ON MANUAL Dual-mount Bathroom Sinks Installation Manual SVWS601, SVWS602, SSVWS603L, SVWS604, SVWS605, SVWS606, SVWS607, SVWS608, SVWS609, SVWS610, SVWS611, SVWS612, SVWS613, SVWS614, SVWS615 www.serenevalleydesign.
PAGE 2
Thank you for your purchase We would like to take this opportunity to thank you for choosing Serene Valley. We hope that you are completely satisfied with your purchase, and enjoy it foryears to come. If you have any questions, or require technical assistance, please contact us by service@serenevalleyhardware.com and one of our representatives will be happy to help. For more information about Serene Valley products, please visit: www. serenevalleydesign.
PAGE 3
Prior to Installation: • Make sure that you have all necessary parts by checking the parts list. If any part is missing or damaged, please contact Serene Valley Customer Service by service@serenevalleyhardware.com for a replacement.
PAGE 4
Tools you willneed: 4 Safety Goggles Drill Silicone Adhesive 4” Hole Saw Pencil Tape Measure
PAGE 5
A: Countertop Installation 1. Mark faucet and drain hole location • Place sink in desired location on countertop and mark drain hole and faucet hole centerline with a pencil NOTE: Make sure clearance is suitable for backsplash, faucet, and sink plumbing 2.
PAGE 6
3. Install sink • Check the alignment of the sink to the opening in the countertop. Use a bead of clear silicone (or preferred adhesive) around the underside of the sink • Carefully place the sink on the countertop, align, and press firmly • Allow sealant to set for 30 – 60minutes Use acetone or rubbing alcohol to remove any excess sealant immediately after application NOTE: 4. Install plumbing fixtures • Connect drain to sink. Connect trap to drain.
PAGE 7
B: Wall-Mount Installation 1. Place the sink in desired location against the wall. Use a pencil to mark the holes for wallmount anchors. 2.Drill holes (9/16”or 14mm in Dia.) on the marks and then insert the anchors.
PAGE 8
3.Insert the install screws inside the anchors. Hammer can be used if necessary. Mount the sink onto the bolts through the install holes. Then tighten the screws with the locking nuts from underneath the sink. 4.Install plumbing fixtures as in countertop installation.