BC950C CBRS Battery Camera Installation Guide Document Version: 1.
Table of Contents 1. Introduction Package Contents 2. Setup System Requirements Physical Details Pre-Installation Installation Mounting Installation 3. Viewing Live Video Overview Connect to The Mobile App 4.
1. Introduction Package Contents The following items below should be included: if any of these items are damaged or missing, please contact your dealer immediately. 1. BC950C Battery Camera x 1 2. Battery Pack x 1 3. Mounting Stand x 1 4. Screw/Anchor x 3 5. USB Cable & Adaptor x 1 2. Setup This section provides details on how to install and configure the Camera. System Requirements ● 2 A computer or mobile device with Internet access, and download the following App on a mobile device.
Physical Details LED Light Table Front Panel Microphone The built-in microphone is bi-directional. Light Sensor The light sensor is to detect the external brightness level. Lens Ensure the lens cover is clean, .this means removing all dirt and smudges from the camera. This is crucial in order to obtain a clear image. IR LEDs The IR LED is to provide illumination at night.
PIR Sensor The PIR sensor is for motion detection. Rear Panel Micro USB Connector Connect the Micro USB cable to the USB port. The Micro USB cable is provided power from external devices. The connection process is as shown in the picture above. Please ensure that the screws are driven firmly into the screw holes. Side Panel SIM Card Reset When pressed and held for over 10 seconds, the LED will flash red, which will return the Camera to its default settings.
Pre-Installation Insert the Battery Pack Align the battery contacts then insert the battery pack into the camera. Note: Fully charge the battery before first use.
Charge Battery Pack Only charge the battery pack indoors with the Micro USB cable provided in the box. Note: Only use the battery within environments of -20°C to 40°C (if AC power is connected to battery pack) or -20°C to 50°C (battery only) : 1. Put the battery pack into the camera. 2. Connect the Micro USB cable to the USB port of the camera. 3. Connect the Plug to the power outlet. LED on Battery Pack Color Status Solid Green The charging is complete. Solid Red The charging is on-going.
Installation 1. 2. Place the camera on a flat surface close to a network connection. Check the LED: ● The Power LED should be solid blue while the camera is powering on. Mounting Installation Place the camera on a flat surface or mount it on the wall or ceiling. Check the network signal strength is sufficient in the place where you want to locate the camera. Avoid placing the camera in an area that gets a lot of light directly into the camera lens. Wall Mounting 1.
3. Viewing Live Video Overview This Chapter provides details of how to view live life video using App downloading from the application store on your mobile phone. Connect to The Mobile App To establish a connection from the Camera to the App: 1. Start App registration. Refer to the other document in the box. 2. Enter a username and password. You will then be prompted for a username and password. 3. After connection, the following screen will be displayed.
4. Troubleshooting Overview This chapter covers some common problems that users may encounter while using the Camera. A few Troubleshooting solutions are also provided. For further advice, please contact your dealer. Problems Problem The camera is offline. Solution 1. 2. Unplug the camera, remove and reinsert the battery, and check the camera LED status. After the camera has turned on - check the LED status. Please check section 2 for more details.
Appendix A Specifications Regulatory Approvals FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.