User's Manual

Installation Instruction
1 Basic Keypad v1.0 2013/11/15
Basic Keypad Installation Guide
Product Description
The basic keypad can provide a convenient interface to enable
control of all system functions. You can use the keypad to arm or
disarm your security system as well as check system status. A
beep will sound when any button is pressed on the keypad.
The keypad is also equipped with a tamper switch. If the kepad
is removed from the wall, the device will generate an alarm and
send it to the AT&T digital Life Central Monitoring Center.
The keypad features are shown in the following figure.
Package Contens
The following items should be included:
• Basic Keypad x 1
• Wall Mounting Plate x 1
• Anchor/Screw x 4
• Battery Cover Screw x 2
• Screw Adapter x 1
• NiMH Rechargeable Battery x 4
Pre-Installation
1. Install the four supplied NiMH rechargeable batteries
correctly.
2. Attach and tighten the battery cover to the keypad with two
supplied Security Torx screws.
NOTE: A special screwdriver is required for installing the
Security Torx screws.
Installation
NOTE: The installation area should be a flat surface. Mounted
it down on an uneven surface could cause damage to the unit.
1. Route the wire (not included) from the control panels
through the opening in the back of the mounting plate.
2. Place the mounting plate in the desired position of the
wall.
NOTE: Make sure the connector pins of the mounting
plate are upward while installing.
3. Use a screwdriver to mount the plate with the included
four anchors/screws through the round holes.
4. Attach and push down the keypad to the plate. Make sure
the device is firmly fixed on the wall.
Sercomm