sepura TETRA Terminals Product Guide MOD-10-1164 Issue 1 © SEPURA PLC 2010
sepura MOD-10-1164 Contents CONVENTIONS _______________________________________________ 4 REGULATORY STATEMENTS ___________________________________ 5 SRG3900 terminals _________________________________________________________ 5 STP8040/STP8140 terminals _________________________________________________ 6 OPERATIONAL REQUIREMENTS ________________________________ 7 Operating Conditions _______________________________________________________ 7 HANDHELD TERMINAL RANGE _________________________________ 8 STP
sepura MOD-10-1164 NOTICE ____________________________________________________ 35 Contact Details ___________________________________________________________ 35 TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 3 of 35 © Sepura plc 2010
sepura MOD-10-1164 CONVENTIONS This guide uses the following formatting and graphical conventions. Convention Description Note icon. Emphasises related, reinforcing, or important information. Tip icon. Suggests alternative methods for accomplishing tasks or procedures. Caution icon. Indicates actions or processes that require caution from the user.
sepura MOD-10-1164 REGULATORY STATEMENTS The following regulatory statements apply to users in the North American and/or Canadian markets. SRG3900 TERMINALS Changes or modifications not expressly approved by the party responsible for compliance could void the user‟s authority to operate the equipment (FCC rule part 15.21). This device complies with part 15 of the FCC Rules.
sepura MOD-10-1164 STP8040/STP8140 TERMINALS Changes or modifications not expressly approved by the party responsible for compliance could void the user‟s authority to operate the equipment (FCC rule part 15.21). This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. (FCC Rule Part 15.
sepura MOD-10-1164 OPERATIONAL REQUIREMENTS All features and functions of Sepura terminals are subject to network support of the TETRA Interoperability Specifications. OPERATING CONDITIONS All Sepura terminals operate in a temperature range between -20ºC and 55ºC and a maximum humidity of 98%.
sepura MOD-10-1164 HANDHELD TERMINAL RANGE STP8000 Series Terminals SRH3000 Series Terminals TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 8 of 35 © Sepura plc 2010
sepura MOD-10-1164 STP8000, STP8100 STP8000 FRONT Antenna Navi-knob™ Emergency Key Blue LED - Tri-colour LED Mode Key Duplex Earpiece and Half-Duplex Microphone Programmable Soft Key Soft Key (Default is Missed Event Key) PTT Rugged Accessory Connector Left Context Key Right Context Key Navigation Keys Cancel / Home Key Send Key Duplex Microphone Alphanumeric Keypad (with Half-Duplex speaker behind) Facility Connector TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 9 of 35 © S
sepura MOD-10-1164 STP8100 FRONT Antenna Navi-knob™ Emergency Key Blue LED - Tri-colour LED Mode Key Duplex Earpiece and Half-Duplex Microphone Programmable Soft Key Soft Key (Default is Missed Event Key) PTT Rugged Accessory Connector Left Context Key Right Context Key Navigation Keys Cancel / Home Key Send Key Duplex Microphone Half-Duplex speaker Facility Connector TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 10 of 35 © Sepura plc 2010
sepura MOD-10-1164 STP8000, STP8100 REAR Antenna Space for User identity label Programmable Soft Key Antenna Connection PTT Carrying aid attachment point Battery Battery release clip To ensure optimal performance from your terminal during half duplex calls (individual or group) please hold the unit vertically, with the half duplex microphone situated approximately 5cm away from the mouth.
sepura MOD-10-1164 STP8000, STP8100 REAR WITH BATTERY REMOVED SIM Card holder/Micro SD card cover (closed) Micro SD card SIM Card holder/Micro SD card cover (open) The SIM Card holder/Micro SD card cover should be left open in radios in storage and latched closed under normal use.
sepura MOD-10-1164 STP8000, STP8100 FACILITY CONNECTOR PEI Car adapter Charger connection STP8000, STP8100 RUGGED ACCESSORY CONNECTOR RSM, Personal audio accessories, Headsets STP8000, STP8100 BATTERIES Fitting and Removing the Battery Before fitting a battery please ensure that the SIM Card holder/Micro SD card cover is latched shut. To fit, unpack the battery and slot it into the rear of the terminal. Push the battery down until the catch clips into the bottom of the case.
sepura MOD-10-1164 Battery Charging New battery packs must be fully charged before they are used. The battery should only be charged using Sepura plc approved battery chargers. Failure to use an approved battery charger may invalidate the warranty of the battery and the terminal. A range of battery chargers is available that allow the battery to be charged while fitted to, or removed from, the terminal (depending upon the charger model selected).
sepura MOD-10-1164 Low Battery Warning. The terminal warns the user when less than 12% of the charge is left by displaying the Low Battery Icon on the top line of the screen and repeatedly flashing the red LED for one second at one second intervals. The Battery Level indicator at the left hand side of the screen is also displayed in red. When the battery is flat there is an audible alert just before the radio switches off. As with all batteries, charging cycles reduce the cell capacity.
sepura MOD-10-1164 3. Use only Sepura approved chargers for charging Sepura products and Sepura approved batteries. The following chargers are recommended and are available from Sepura: Personal Rapid Charger Part No. 300-00381 In Car Rapid Charger Part No. 300-00382 Desktop Charger 1+1 Part No. 300-00383 Desktop Charger 6+6 Part No. 300-00384 Non-approved chargers may incorrectly charge the battery, leading to premature failure, or render the battery potentially unsafe. 4.
sepura MOD-10-1164 The Belt Clip Metal spring Attaching The Belt Clip to the radio To attach the belt clip to the radio slide it into the carrying aid attachment recess as shown. Detaching the Belt Clip from the Radio To remove the belt clip from the radio first carefully pull or lift the bottom end of the belt clip away from the radio.
sepura MOD-10-1164 Use your thumb or thumb nail to compress the metal spring and release the belt clip. It is then possible to pull the belt clip so that it slides out of the carrying aid attachment recess. The “Klick Fast” Stud The “Klick Fast” Stud may be attached to the radio in the same way as the belt clip and detached in a similar way by compressing the spring (which may be plastic) with the thumb or thumb nail.
sepura MOD-10-1164 SRH3500, SRH3800, SRH3900 FRONT Antenna Navi-knob™ Emergency Key Tri-Colour LED Mode Key PTT Duplex Earpiece and Half-Duplex Microphone Navigation Keys Cancel/Home Key Select/Send Key Alphanumeric Keypad Duplex Microphone Facility connector TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 19 of 35 © Sepura plc 2010
sepura MOD-10-1164 REAR Half duplex loudspeaker Antenna User identity label recess Carrying aids mounting points Audio Accessories Socket Battery Battery release clip TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 20 of 35 © Sepura plc 2010
sepura MOD-10-1164 FACILITY CONNECTOR PEI, Car adapter, Personal Rapid Charger connection, RSM connector ACCESSORIES SOCKET Audio Accessories socket BATTERIES Fitting and Removing the Battery To fit, unpack the battery and slot it into the rear of the hand-held. Push the battery down until the catch clips into the bottom of the case. The battery is fully secure when this catch has clipped into position. To remove, push the catch upward towards the top of the hand-held.
sepura MOD-10-1164 Battery Charging The battery should only be charged with Sepura plc approved battery chargers. Failure to use an approved battery charger will invalidate the warranty of the battery and the hand-held. A range of battery chargers is available that allow the battery to be charged while fitted to, or removed from, the hand-held (depending upon the charger model and hand-held type selected).
sepura MOD-10-1164 the battery and charger very near to curtains, soft furnishings, paper or other combustible material. 2. Copy batteries are available for many products, particularly mobile phones and more recently TETRA radios, including those made by Sepura. These may be cheaper than approved batteries, but may not include protection features used in the approved battery, so may be less safe and should not be used. 3. Use only Sepura approved chargers for charging Sepura products.
sepura MOD-10-1164 MOBILE / GATEWAY TERMINAL RANGE SRM3000, SRG3000 Series Terminals SRM3000, SRG3000 Series Consoles Applications Interface Unit TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 24 of 35 © Sepura plc 2010
sepura MOD-10-1164 SRM3000, SRG3000 MOBILE / GATEWAY TRANSCEIVER Console Ports or Dual PEI Ports Antenna Connector Power, audio and external control lines GPS Antenna Connector In order to operate the following components are required: TETRA Mobile / Gateway Transceiver Unit Power Cable Assembly An Antenna Optional accessories that may be included: Standard Console or Handset Based Console Unit Applications Interface Unit The Mobile or Gateway Terminal should be installed by following the inst
sepura MOD-10-1164 STANDARD CONSOLE Tri-Colour LED Navi-knob™ (rotate) Mode Button (press) Select/Send Key Emergency Button Alphanumeric Keypad Navigation Keys Cancel/Home Key PEI Port HANDSET BASED CONSOLE Front Navi-Keys Emergency Key Mode Key PTT Navigation Keys Select/Send Key Cancel/Home Key Alphanumeric Keypad TETRA Terminals Product Guide th March 26 2010 Issue 1 Page 26 of 35 © Sepura plc 2010
sepura MOD-10-1164 Rear Earpiece Microphone APPLICATIONS INTERFACE UNIT Accessory Connection Connection to Transceiver PTT Jack Socket Programming Lead Connection Microphone Jack Socket TETRA Terminals Product Guide th March 26 2010 Issue 1 Accessory Connection (not used if Jack Sockets are in use) Page 27 of 35 © Sepura plc 2010
sepura MOD-10-1164 MOBILE / GATEWAY TERMINAL ACCESSORIES CONSOLE AND APPLICATIONS INTERFACE UNIT The Mobile/Gateway terminal supports the connection of up to two console units. Each console unit can be a Standard Console or a Handset Based Console, complete with keypad and display, or an Applications Interface Unit, which is similar to a console but which does not have a keypad and display. This enables the mobile to support the connection of up to four audio accessories.
sepura MOD-10-1164 If the controlling accessory is placed on-hook this clears the call unless customised differently. Other accessories can be put back on-hook without clearing the call in progress. All earpiece audio is left on all the time in order that multiple users may listen to the received audio. The audio presentation for duplex calls depends on the capability of the controlling accessory. With a duplex controlling accessory, duplex calls have a duplex presentation.
sepura MOD-10-1164 RADIO OPERATION See the Sepura Terminal User Guide for information regarding the user operation of the terminals.
sepura MOD-10-1164 HEALTH AND SAFETY USER INFORMATION CARE OF YOUR TERMINAL Use only a slightly damp soft cloth for cleaning all exterior surfaces. Do NOT use chemical aerosol or abrasive cleaners. To ensure efficient operation, clean the battery contacts periodically with a soft, dry cloth. Never leave the terminal in extreme temperatures (over 55°C), for example behind glass in very hot, direct sunlight.
sepura MOD-10-1164 Use of the emergency key whilst in Transmit Inhibit is supported; however, the time to set up the emergency call could be increased by a few seconds. ANTENNA When fitting the antenna, do not over-tighten. Do not use the terminal without the antenna attached unless the terminal is being used with an external antenna (e.g. on RSM). ACOUSTIC SHOCK Sepura plc has engineered an innovative audio solution for the terminal.
sepura MOD-10-1164 GLOSSARY Term Description Gateway A device which allows users working in Direct Mode to communicate with users in Trunked Mode. (This is often used to extend the working range of a radio) Duplex Duplex calls are telephone type calls in which both parties can talk simultaneously. ETSI European Telecommunications Standards Institute Half duplex Half duplex calls are when only one party can talk (transmit) at any time.
sepura MOD-10-1164 ACKNOWLEDGEMENTS 1) The Sepura STP8000 and STP8100 series terminals contain iType™ from Monotype Imaging Inc. ® 2) The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Sepura plc is under licence. Other trademarks and trade names are those of their respective owners. ® Bluetooth Qualified Device ID : B013965 3) The Independent JPEG Group The Radio software is based in part on the work of the Independent JPEG Group.
sepura MOD-10-1164 NOTICE All rights reserved. This document may not be reproduced in any form either in part or in whole without the prior written consent of Sepura plc, nor may it be edited, duplicated or distributed using electronic systems. Company and product names mentioned in this document may be protected under copyright or patent laws. The information in this document is subject to change without notice and describes only the products defined in this document.
