User's Manual

ManualsBrandsSEOYON ELECTRONICS ManualsElectronicsRemote Keyless Entry System

Title : NO. : SCE-0713

Date : 08. October. 2007

1. PRODUCT SPECIFICATION

1.1 Scope of Remote Keyless Entry in ETACS system.

1.1.1 Key part : Transmitter is inside of the remote key, and it

sends the rolling code to the receiver by radio frequency.

1.1.2 Receiver : It receives the rolling code and decodes that,

thereafter receiver drives the actuator.

1.2 Specification

1.2.1 Transmitter

1.2.2 Receiver

Page 3 of 12

Storage temperature range

-30 ~ 80℃

Modulation FM

Item

Specification

Rated supply voltage DC 3V

Operating voltage range DC 2.5 ~ 3.2V

Operating temperature range

-20 ~+60℃

Electric field strength 0.01mW

Frequency 315MHz

Code Rolling Code(Hopping Algorithm)

- 30 ~ + 80℃

Max Humidity 95%

Battery life 2 Year(Lithium 3V 1EA)

Below than 6mA

(in alarm setting condition)

Standby Current

Specification

Item

DC 9 ~ 16V Operating Voltage

DC 12V Rated Supply Voltage

Operating Temperature

Information Document

Summary of content (4 pages)

PAGE 1
Title : NO. : SCE-0713 Information Document Information Document Date : 08. October. 2007 1. PRODUCT SPECIFICATION 1.1 Scope of Remote Keyless Entry in ETACS system. 1.1.1 Key part : Transmitter is inside of the remote key, and it sends the rolling code to the receiver by radio frequency. 1.1.2 Receiver : It receives the rolling code and decodes that, thereafter receiver drives the actuator. 1.2 Specification 1.2.1 Transmitter 1.2.
PAGE 2
Title : NO. : SCE-0713 Information Information Document Document Information Document Date : 08. October. 2007 2. USER MANUAL 2.1 Name : ETACS system - This system is ETACS and includes RKE. - RKE in ETACS system is intended for auto door lock or unlock in vehicle. - This ETACS system is to be installed on motor vehicles as *OE item. * OE : Original Equipment. * ETACS : Electronic Time & Alarm Control System. * RKE : Remote Keyless Entry. 2.2 System construction 2.2.
PAGE 3
Title : NO. : SCE-0713 Information Document Information Document Date : 08. October. 2007 2.3 Operating summary ① Transmitter's button is pushed. ② Transmitter sends the code by radio frequency. ③ Receiver gets the code and decodes it. ④ Receiver judges the code whether it is right code or not. ⑤ Receiver checks door lock or unlock state. ⑥ Receiver drives the actuator. ⑦ Receiver drives the horn 2.3.1 Lock & Unlock If transmitter's button is pushed, Transmitter sends the code. 2.
PAGE 4
"CAUTION: Exposure to Radio Frequency Radiation. Antenna shall be mounted in such a manner to minimize the potential for human contact during normal operation. The antenna should not be contacted during operation to avoid the possiblility of exceeding the FCC radio frequency exposure limit. The minimum separation distance of 20cm from the antenna to the body of user required.