Full Product Manual

1. Put in 3 AAA batteries. (not included)

2. Create White/Black List (without names)

3. Connect SENTRY in between your phone and wall jack. (see diagram)

• Use key pad to punch in the phone number with area code.

(Verify if “1” prex if required)

• Press ACCEPT to save on White List; REJECT to save on Black List .

• To correct, use DEL/EXIT.

Create White List with names (optional)

• Press and hold ACCEPT until you see _ _ _

• Use dialpad to input phone number (area code + number)

• Press ACCEPT to save number, then enter name using dialpad, press ACCEPT again to save both number and name.

• To correct, use DEL/EXIT.

Record your own outgoing message (optional)

• To listen to default OGM, double click REC/PLAY.

• To record your own OGM, press and hold REC/PLAY until ‘beep’, release button, then start recording(up to 20 seconds). Press

REC/PLAY again to stop and play back. To re-record, repeat above steps.

• Double press REC/PLAY to listen to OGM, double click DEL/EXIT to erase.

• Press OGM D/C button to choose C (custom message)

Line Phone

SENTRY

SENTRY is ready now.

Custom set up

Quick Set Up (recommended)

Active Call Screener v3.1

PAGE 1
Active Call Screener v3.1 Quick Set Up (recommended) 1. Put in 3 AAA batteries. (not included) 2. Create White/Black List (without names) • Use key pad to punch in the phone number with area code. (Verify if “1” prefix if required) • Press ACCEPT to save on White List; REJECT to save on Black List . • To correct, use DEL/EXIT. 3. Connect SENTRY in between your phone and wall jack. (see diagram) SENTRY is ready now.
PAGE 2
Functions A B A. BLOCK NO CID – Block all calls without caller ID C B. Number of unchecked incoming calls C. OGM – D: default, C: custom, OFF: allow all calls except Black Listed D. UP/DOWN – Scroll through entries D E. REJECT – Add to Black List, check Black List E F. DEL/EXIT – Exit or Save, double press to delete an entry G. REC/PLAY – Record your custom message, play caller messages H. OGM D/C – Warning message options, D: default, C: custom, (SENTRY ON) I.
PAGE 3
Functions (less used) 1. Delete a number from White List: press ACCEPT, then UP/DOWN to find that number, press DELETE twice to delete. 2. Redo custom message. Refer to Custom Set Up. 3. Turn off SENTRY’S ringer: press RINGER to choose RINGER ON or OFF, press DEL/EXIT to save. 4. Turn on BLOCK NO CID: Press and hold REJECT until BLOCK NO CID shows on screen. Then press Up/Down to toggle. All calls with no CID will be rejected directly. 5.