Transmitter Certification Test Report FCC ID: SDBGFL FCC Rule Part: CFR 47 Part 24 Subpart D, Part 90 Subpart I, Part 101 Subpart C ACS Report Number: 06-0194-LD Applicant: Advanced Metering Data Systems, LLC Equipment Type: Water Meter Data Transmitter Trade Name: Sensus AMDS GFL Gas Meter Transmitter Model(s): GFL Users Manual 5015 B.U.
Product Description The FlexNet® wireless transmitter for gas AMR applications permits offsite meter reading by way of a fixed base radio network. In addition to solving meter reading problems such as lockouts, entering unsafe meter locations, "curbside" reading estimates, estimated billing, and errors associated with manual meter reading methods, a fixed network provides benefits such as daily reads and status alerts. A significant advantage of the module is its powerful one- Watt transmitter.
Automated Meter Reading (AMR) Meter Components Transmitter Cover Supported Meters FlexNet 100G-FL AC250, AL175, AL250, AL5B (=AL225), AL425 and any other American Meter model with a standard residential index. FlexNet 200G-FL S175, S240, S250, Schlumberger Metris MET250 and S400, with slant index interface. FlexNet 300G-FL AC250, AL175, AL250, AL5B (=AL225), AL425 and any other American Meter model with a standard residential index.
Transmitter Mounting Instructions FlexNet 100G-FL, 200G-FL and 300G-FL See the appendix for descriptions of the screw kits and tools required for mounting the AMR transmitters. Remove Index Cover 1. Use a small, flat screwdriver to punch out the snap seals covering the index cover screws. NOTE: If two (2) or more screws shear off during the cover removal (or were previously sheared off), the meter will need to be replaced by a qualified utility representative.
Use care when working with a power screwdriver to insert screws in the plastic Transmitter box. Over tightening will damage the box and/or weaken the contact. Failure to comply with this caution can result in damage to the equipment. 7. Secure the cover to the transmitter with the index cover screws. 8. Align and insert the two snap seals into the index cover using a ¼” nut driver until the snap seals are fully seated. FlexNet 700G-FL Pulse Output Identification 1.
Initialize Transmitter Use a Sensus handheld terminal (HHT) to initialize the transmitter.
Appendix: Screw Kits and Tools Screw Kits Screw kits accompany the AMR transmitters. Each kit contains any of the following (depending on transmitter model): • • • • • • Mounting screws Index screws Index cover screws Snap seals 3M Scotchlok® UY-2 butt connector “gel-caps” Pipe clamp Mounting Screws 1. 2. 3. 4. 5. Equimeter/Rockwell commercial meter (e.g. R750) – 5/16” x 3½” combo fillister American commercial meter (e.g. AL800) – #18-18 x 84 Phillips pan head American residential meter (e.g.
APPENDIX A: REGULATORY INFORMATION: COMPLIANCE INFORMATION: FCC: NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
APPENDIX B: REGULATORY LABELING FCC LABELING: This device when used in an end product where the FCC label of the device is not visible must have an exterior label as shown below. Contains FCC ID: SDBGFL Contains IC: 2220A-GFL This device complies with Part 15 of the FCC Rules and Industry Canada requirements.