Model 510 Installation Instructions
Definitions 1 4 2 3 5 6 1 – Sensus TouchPad 2 – TouchPad Cover 3 – TouchPad Cover, Tinnerman Type Fastener, TouchPad Locking Clip 4 – Model 510 Radio (Front View) 5 – Model 510 Radio (Rear View with knockout) 6 – Model 510 Radio and TouchCoupler Spacer with TouchPad Cover 2
Table of Contents Single Port – TouchCoupler Installation ____________________________________ 4 Dual Port – TouchCoupler Installation _____________________________________ 5 Single and Dual Port – Wired Installation ___________________________________ 6 Activate Radio__________________________________________________________ 7 Appendix A: ___________________________________________________________ 9 Appendix B: Regulatory Information _____________________________________ 12 3
Single Port – TouchCoupler Installation 1) While Model 510 Radio and TouchCoupler Spacer with TouchPad Cover all still assembled, align the TouchPad Cover over the Sensus TouchPad that is secured to the wall and press on whole assembly. 2) For additional support, open Model 510 Radio door and screw two screws using the holes located above the battery compartment. 3) Once secured, activate unit (see activation section).
Dual Port – TouchCoupler Installation 1. First choose which Sensus TouchPad will be covered remotely. Place the remote the TouchPad Cover over the Sensus TouchPad. 2. While Model 510 Radio and TouchCoupler Spacer with TouchPad Cover all still assembled, align the TouchPad Cover over the Sensus TouchPad that is secured to the wall and press on whole assembly. 3. For additional support, open Model 510 Radio door and screw two screws using the holes located above the battery compartment. 4.
Single and Dual Port – Wired Installation 1. Open Model 510 Radio door. 2. Secure Model 510 Radio to a wall utilizing the screw holes above the battery compartment. 3. Run the register wires through the bottom of the Model 510 Radio and connect to the appropriate terminals. 4. Once all registers are connected, activate unit (see activation section).
Activate Radio Note: if no meters are connected to this radio, the radio will not activate. 1.) Once all meters are connected, the radio must be activated in order for it to perform its function. To activate, using a TouchReader or Model 4090 AutoGun, attempt a TouchRead on the Programming/TouchRead port (See picture below). Once TouchRead is activated, the radio will determine what is connected to this unit automatically.
• ID: MXUGPTC1 – which means a TouchRead was attempted on an unsupported meter (Neptune). • ID: MXUGPTC2 – which means that the port was configured for a mete r type that supports TouchRead (Sensus only) but there was no response from the meter. 5.) If unsuccessful detection, the TouchRead will start the activation process again. The ID on the AutoGun will display MXUGPTC0 similar to the step 2 above.
Appendix A: The following photos show how the PCB is oriented and installed into an enclosure.
Appendix B: Regulatory Information FCC Information to User: Changes or modifications not expressly approved by Sensus Metering Systems could void the user's authority to operate the equipment. In order to meet FCC’s RF exposure limits in section 1.1307 of the Rules, a minimum separation of 20 cm must be maintained between the antenna of this device. The antenna(s) used for this transmitter must not be co- located or operating in conjunction with any other antenna or transmitter.