USER MANUAL For TEMPTALE ULTRA BLE NOTICE OF PROPRIETARY PROPERTY This document and the information contained in it are the proprietary property of Sensitech. It may not be copied or used in any manner nor may any of the information in or upon it be used for any purpose without the express written consent of an authorized agent of Sensitech Inc.
REVISION HISTORY: REV 2 3 4 5 DESCRIPTION Initial Release Updated Disclaimer; Remove Watermark Draft stamp Updated FCC and IC Disclosure Updated Radiation Exposure DWN JZL JZL JZL JZL APVD TNS TNS TNS TNS DATE 03AUG21 16SEPT21 20SEPT21 23SEPT21
Table of Contents 1. 2. 3. 4. 5. Introduction ............................................................................................................... 4 1.1. Purpose ......................................................................................................... 4 1.2. Scope............................................................................................................. 4 1.3. Description ........................................................................................
1. Introduction 1.1. Purpose This document describes the usage of a TEMPTALE ULTRA BLE device. 1.2. Scope The intended audience is a valued customer. 1.3. Description The TEMPTALE ULTRA BLE is a BLE enabled sensor data logger designed for the transportation industry. It is primarily intended to be used to record and store accurate temperature data as well as transmit the data to a Bluetooth enabled smart phone or tablet device via a mobile application.
2. Physical Appearance 2.1. User Interface The user interface consists of the following: 1. Three LEDs (red, green, blue) 2. Two buttons(Start/Stop) 3. One LCD Display 2.1.1. LEDs The LEDs are intended to allow quick and easy-to-read status to be conveyed to the end user. The user can immediately know the status of the unit during startup and operation. 2.1.1.1. System Startup Sequence During startup, and If configured the Green LED blinks at 1hz for 4 secs. 2.1.2.
2.1.3. LCD There is a LCD on the device: During Startup, if there is a hardware failure found during the self-test, a X will display on the LCD and the Stop sign will appear. © SENSITECH INC.
3. Using the Device 3.1. Starting the device: To start the device, press the START button. If the Start Key feature is enabled, the START button must be held down for 3 seconds. The device may only be started from sleep mode. 3.2. Stopping the device: There are 2 methods for stopping the device. 1. To stop the device, press the STOP button. If the Stop Key feature is enabled, the STOP button must be held down for 3 seconds to stop. 2.
5. Disclaimers RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
5.1.1 FCC Radiation Exposure Statement This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. 5.2. IC This device complies with Industry Canada RSS standard(s).