User's Manual

Sensitech Inc. • 800 Cummings Center • Beverly, MA 01915

(978) 927-7033 • Fax (978) 921-2112 www.sensitech.com

TempTale is a registered trademark and TagAlert is a trademark of Sensitech, Inc.

800 Cummings Center, Beverly, MA 01915 T11012177 Rev. B.

TempTale

Monitor

Instructions For Use

The Tools That Turn Information Into Power

TempTale

Manager Software Data Management Services

TempTale

4 Monitor TagAlert

™

Monitor

Millions Depend on the Integrity of Your Product.

Sensitech’s Mission is to Ensure that Integrity.

For more information, contact our client services

group at 800-843-8367.

RF Monitoring

TempTale

4 Probe Monitor

FCC ID SRMT11012177

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful

interference, and (2)this device must accept any

interference received, including interference that

may cause undesired operation.

Changes or modifications not expressly approved

by Sensitech could avoid the user’s authority to

operate the equipment.

PAGE 1
Millions Depend on the Integrity of Your Product. Sensitech’s Mission is to Ensure that Integrity. The Tools That Turn Information Into Power TempTale RF Monitor ® Instructions For Use TempTale® Manager Software TempTale®4 Probe Monitor Data Management Services TempTale®4 Monitor RF Monitoring TagAlert™ Monitor For more information, contact our client services group at 800-843-8367. © 2010. All Rights Reserved. TempTale is a registered trademark and TagAlert is a trademark of Sensitech, Inc.
PAGE 2
All TempTale® RF Monitors can be programmed with a custom Start-up delay, measurement interval and alarm settings which have been predetermined by the customer. Starting a TempTale RF Monitor • • • Iniciar el TempTale RF Press and release the Start button. The “Sunshine” icon appears in the upper left corner of the display. The TempTale RF will begin to record data after the start-up delay has passed.
PAGE 3
RADIO AND TELEVISION INTERFERENCE NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.