Installation Instructions

Sigfox_RCZ2 Installation

1. RCZ2_Module Top and Bottom side following Fig.1.

Fig.1 RCZ24 Module schematic diagram

2. TR_SIGFOX_RCZ24 carrier board following Fig.2.

Fig.2 TR_SIGFOX_RCZ24 carrier board schematic diagram

3. TR_EVERDAY Control Board Top and Bottom side following

Fig.3.

Fig.3 TR_EVERDAY PCB schematic diagram

PAGE 1
Sigfox_RCZ2 Installation 1. RCZ2_Module Top and Bottom side following Fig.1. Fig.1 RCZ24 Module schematic diagram 2. TR_SIGFOX_RCZ24 carrier board following Fig.2. Fig.2 TR_SIGFOX_RCZ24 carrier board schematic diagram 3. TR_EVERDAY Control Board Top and Bottom side following Fig.3. Fig.
PAGE 2
4. Solder the module on the carrier board. Fig.4 Module_Sigfox_RCZ2 on the carrier board 5. Solder carrier board on the TR_EVERDAY Control Board. Fig.
PAGE 3
6. Burn software to control board following Fig.6. Fig.
PAGE 4
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 5
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.