User's Instructions

http://www.tpmseuroshop.com/documents/declaration_conformities
The device under test is manufactured by the grantee (Sensata Technologies) and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must
ensure the end-user has all applicable / appropriate operating instructions. When end-user
instructions are required, as in the case of this product, the grantee must notify the OEM to
notify the end- user. Sensata Technologies will supply this document to the
reseller/distributor dictating what must be included in the end user’s manual for the commercial
product.
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following information (in blue) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers
must be included in the manual if the device label is not readily accessible to the end
user. The compliance paragraphs below must be included in the user's manual.
FCC ID: 2ATIMBREX IC: 25094-BREX
This device complies with Part 15 of the FCC Rules and with Licence exempt RSS standards of
Industry Canada. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'ISDE Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1. L’appareil ne
doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
Note: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment should be installed and operated with a Minimum distance of 20cm Between
the radiator and your body. This transmitter module must not be co-located or operating in
conjunction with any other antenna or transmitter. Co-location with other transmitter antennas
would require the use of FCC multi-transmitter product procedures.
Cet équipement est conforme aux limites d'exposition aux radiations de la FCC et de l'ISDE
établies pour un environnement non contrôlé. Ce module émetteur ne doit pas être co-localisé
ou fonctionner en conjonction avec une autre antenne ou un autre émetteur. La
co-localisation avec d’autres antennes d’émetteur nécessiterait l’utilisation des procédures
FCC relatives aux produits multi-émetteurs.
WARNING: Changes or modifications not expressively approved by the party responsible for
compliance could void the user's authority to operate the equipment. The term “IC:” before the
radio certification number only signifies that Industry Canada technical specifications were met.