Instruction manual

Getting started
Sennheiser TV Clear Set | 19
Connecting your earbuds to the transmitter „TV Connector“
If it is the first time connecting the earbuds to the TV Connector, you
must put them into pairing mode as described in chapter
“Put the
earbuds into pairing mode” (> 17). After they have been paired, the
earbuds should connect automatically when removed from the case.
1. Make sure the transmitter is properly connected to the TV or
sound source (>
15) and switch it on (> 22).
2. Press the pairing button on the back of the transmitter.
The transmitter will now connect to the earbuds and the indicator
lights of the charging case will stop blinking.
3. Insert the earbuds into both ears. You will hear a confirmation
when inserted. The sound from your transmitter will be played
through the earbuds when connected.
Additional information about pairing
• The earbuds can be paired to a maximum of 6 devices. A 7th pair-
ing will replace the least used device.
• All 3 indicator lights will blink blue during pairing. This can take
up to 2 minutes, but typically is finished within a few seconds.
• The earbuds must be paired only once to a phone, tablet or trans-
mitter „TV Connector“. Devices remain paired after powering off
and will reconnect automatically when powered on if they are
within reach.
• To connect manually, go to your devices Bluetooth menu, select
“Sennheiser TV Clear” from the list or short press either of the
earbud buttons while wearing them.
When the transmitter was purchased in the TV Clear Set,
transmitter and earbuds are already paired during production.
Just open the lid of the charging case and proceed to the chap
-
ter “Daily use of the transmitter TV Connector” (> 22).
1 2
3
ON
LED