Instruction manual
SL DI 4 XLR 5/11
The SL DI 4 XLR Dante™ interface
Daisy-chaining the power supply
The PWR LINK IN and OUT terminals allow you to daisy-chain the power supply to additional de-
vices.
The number of devices that can be daisy-chained is limited.
• NT 12-50CS power supply -> maximum of 3 devices.
• Power over Ethernet -> maximum of 2 devices
WARNING!
DANGER OF INJURY DUE TO MISSING OVERLOAD PROTECTION!
IF THE DAISYCHAINING OF THE POWER SUPPLY IS NOT DONE PROPERLY, THIS MAY CAUSE IN
JURY DUE TO ELECTRIC SHOCK.
Only have the daisy-chaining of the power supply done by a qualified specialist.
Connecting audio signals
You can connect a total of four analog audio signals (e.g. from microphone receivers (SL Rack
Receiver DW) or wired microphones) to the SL DI 4 XLR.
You can change the settings for the respective microphone input using the SL DI CONTROL soft-
ware (see „Configuring the SL DI 4 XLR using the SL DI CONTROL software“).
To connect analog audio signals to the SL DI 4 XLR:
Use an XLR-3 cable to connect the audio device to one of the four XLR inputs.
Via the DATA and POE + DATA Ethernet sockets, the audio signals are routed, using Dante™, to a
Dante™-enabled device.
The destination of the Dante™ stream is configured using a Dante™ software controller. This con-
troller is not part of the SL DI CONTROL software..
POE + DATADATA
IN 4 IN 3 IN 2IN 1
4x analog audio in
2x Dante
® audio out
Examples: