Instruction manual Digital 9000 System

Using the SK 9000
98 | Digital 9000
“Tune”– Setting a frequency
Via the “Tune” menu item, you can set a frequency. The frequencies are
tuneable in 25 kHz steps. If you store your setting, the set frequency is
automatically assigned to the user-defined frequency preset “U”. The
bodypack transmitter then changes from the currently set frequency pre-
set to the frequency preset “U” and transmits on the set frequency.
“Preset” – Selecting a frequency preset
Via the “Preset” menu item, you can select a frequency preset from the
active booster frequency range or the frequency preset “U” (see also the
“Tune” menu item).
“Name” – Entering a name
Via the “Name” menu item, you can enter a freely selectable name for the
bodypack transmitter. The name can consist of up to 6 characters from the
following character set:
“Gain” – Adjusting the input gain
Via the “Gain” menu item, you can adjust the input gain in 3 dB steps from
-6 to +42 dB.
“Low cut” – Setting the low-cut filter
Via the “Low cut” menu item, you can set the low-cut filter. The bodypack
transmitter automatically detects the type of input signal present and
changes the settings of the “Low cut” menu item accordingly. If you are
using the Sennheiser CI 1-4 line/instrument cable, the “Low cut” menu
item is hidden.
Reset
Resets the factory default set-
tings
99
Information Displays the firmware version
and frequency range
99
a. If you are using the Sennheiser CI 1-4 line/instrument cable, this menu item is
hidden
b. If you are using the Sennheiser CI 1-4 line/instrument cable, this menu item is
shown
Icon Name Function Page
To activate a different booster frequency range:
왘 Proceed as described from page 56 onwards. You first activate
the booster frequency range on the EM 9046. If you then syn-
chronize the transmitter and the receiver, the booster frequency
range on the transmitter will also be activated.
`+` `,` `-` `|` `/` `0` `1` `2` `3` `4` `5` `6` `7` `8` `9` `*` `;` `<` `=` `>`
`space` `#` `A` `B` `C` `D` `E` `F` `G` `H` `I` `J` `K` `L` `M` `N` `O` `P`
`Q` `R` `S` `T` `U` `V` `W` `X` `Y` `Z`
Cable type Settings
Sennheiser microphone cable “60 Hz”, “80 Hz”, “100 Hz”, “120 Hz”
Sennheiser CI 1-4
line/instrument cable
“30 Hz”, the “Low cut” menu item is
hidden