Instruction manual Digital 9000 System

Using the SK 9000
94 | Digital 9000
Using the SK 9000
Switching the SK 9000 on/off
To switch the SK 9000 on:
왘 Keep the ON/OFF button 2 pressed until the Sennheiser logo
appears on the display panel C.
The ON LED 3 lights up and the standard display (here: “Frequency”,
see page 99) appe
ars on the display panel C. The bodypack transmitter
transmits an RF signal and the transmission mode display “HD”/“LR”
lights up constantly:
To switch the SK 9000 off:
왘 Ke
ep
the ON/OFF button 2 pressed until the display panel goes off.
왘 Remove the accupack/battery pack when the transmitter will not be
used for extended periods of time (see page 43).
To switch the SK 9000 off with the lock mode activated:
왘 Press t
he ON/OFF button B while the standard display is shown.
“LOCK” appears on the display panel because the lock mode is activated.
왘 Press
the UP button or the DOWN button .
“UNLOCK” appears on the display panel.
왘 Press
th
e SET button .
The lock mode is temporarily deactivated, the lock mode icon 5 flashes.
왘 Within the next 2 seconds, press the ON/OFF button B and keep it
pressed until the display panel goes off.
왘 If you switch on the SK 9000, the lock mode is activated again.
Before using your bodypack transmitter, ask the relevant wireless
regulatory authority for the exact frequency allocations and apply
for an individual license if necessary.
The supplied supplement “Framework requirements and restrictions
on frequency usage in Europe” provides an overview of the different
European framework requirements and restrictions on frequency
usage. If there is no entry in the supplement, ask the relevant wire-
less regulatory authority for the current rules governing frequency
usage.
When the SK 9000 is switched on for the first time, it contains the
first frequency preset of the transmitter frequency range (e.g. A1.1:
470.200 MHz). Via the “ch” menu of the EM 9046 receiver, set the
desired frequency preset and adjust the settings of other menu
items and then synchronize the transmitter and the receiver (see
page 77). In doing so, all frequency presets of the transmitter fre-
quency range will be transfered to the SK 9000.
We recommend you to always adjust the transmitter settings via
the EM 9046 receiver and then to synchronize the transmitter and
the receiver.
2
3
C
3:59
480.000
3:59
480.000