Instruction manual Digital 9000 System

Digital 9000 | 67
Using the EM 9046
“
Screensaver”
The “Screensaver” menu item adjusts the “Brightness” to the lowest
(menu-selectable) value, independent of the user-set “Brightness” value.
The “Screensaver” is activated after 30 minutes if the following conditions
are met:
•The “Screensaver” menu item is set to ON.
• No entry via button or jog dial for 30 minutes.
• No RXD card connected to a transmitter for 30 minutes.
The described “Screensaver” state is deactivated and the 30 minutes timer
is restarted if:
• a button is pressed (the function of the button is also performed)
• the jog dial is turned or pressed (the function of the jog dial is also per-
formed)
• the Standby button 3 is pressed
•
a tr
ansmitter is switched on and its signal is received by an RXD card.
The timer remains deactivated as long as the RXD card is connected to
the transmitter
• an error message is displayed over the whole screen. The timer remains
deactivated until the error message is confirmed and is quit using the
esc button L
The described screensaver state remains unchanged if:
• the headphone volume control is turned, i.e. the “Screensaver” remains
active and the screen will not brighten since the headphone volume
control is considered a pure volume control not related to the screen
The “Screensaver” timer is inactive as long as one of the following condi-
tions is met:
•The “Screensaver” menu item is set to OFF.
• An RXD card is connected to a transmitter.
• An error message is displayed over the whole screen.
Extended menu “Service setup”
To get into the extended menu “Service setup”:
왘 In “sys” operating mode, turn the jog dial until “Service setup” appears.
왘 Press the jog dial.
The extended menu “Service setup” appears.
To change from the extended menu back to the main menu:
왘 Turn the jog dial until “System setup” appears.
왘 Press the jog dial.
You are back to the main menu “System setup” of the “sys” operating
mode.