Instruction manual Digital 9000 System
Table Of Contents
- Digital_9000_Manual_06_2017_EN
- Important safety instructions
- Digital 9000 – System overview
- Delivery includes
- EM 9046 receiver
- EM 9046 CAB cable set
- Antennas and antenna boosters
- GZL 9000 antenna cables
- SKM 9000/SKM 9000 COM radio microphone
- Microphone heads for the SKM 9000 radio microphone
- SK 9000 bodypack transmitter
- Microphones for the SK 9000 bodypack transmitter
- KA 9000 COM command adapter for the SK 9000 bodypack transmitter
- CI 1-4 line/instrument cable for the SK 9000 bodypack transmitter
- B 60/B 61 battery packs
- BA 60/BA 61 accupack
- L 60 charger
- Product overview
- EM 9046 receiver
- Antennas and antenna boosters
- GZL 9000 antenna cable
- SKM 9000/SKM 9000 COM radio microphone
- SK 9000 bodypack transmitter
- KA 9000 COM command adapter for the SK 9000 bodypack transmitter
- BA 60 accupack
- BA 61 accupack
- B 60 battery pack
- B 61 battery pack
- L 60 charger
- Preparing the EM 9046 receiver for use
- Preparing the A/AB/AD 9000 antennas and/or antenna boosters for use
- Preparing the SKM 9000 radio microphone for use
- Preparing the SK 9000 bodypack transmitter for use
- Preparing the L 60 charger for use
- Cascading several chargers
- Setting up or mounting the charger
- Preparing the Digital 9000 system for use
- Using the EM 9046
- Using the SKM 9000
- Using the SK 9000
- Using the L 60
- Cleaning and maintaining the Digital 9000 system
- If a problem occurs ...
- Specifications
Using the EM 9046
66 | Digital 9000
The following settings/values are not saved:
• time and date settings of the “Date & time” menu item (see page 69)
and
•operating hours (displayable via the “op hours” menu item, see page
69).
“Network” – Configuring the network
Via the “Network” menu item, you can assign the receiver a network name
and select whether to obtain an IP address automatically or to enter the IP
address manually. In addition, this menu item displays the unchangeable
MAC addresses of the network interfaces of your receiver.
“Brightness” – Adjusting the brightness
Via the “Brightness” menu item, you can adjust the brightness in 8 steps.
This also adjusts the brightness of the LED lighting.
Main menu
“Channel setup”
Frequency 77
Name 78
Cmd mode 78
Encryption 79
Gain 82
Low cut 82
Display 83
Lock 83
Cable 83
Menu Menu item Page
Name
network
169.254.92.238
EM 9046
IPv4 address
Slot analog:
IPv4 address:
subnet mask:
gateway:
EM 9046
auto
auto
auto
192.254.95.238
255.255.0.0
0.0.0.0
LAN UP:
LAN DOWN:
00:1b:66:fe:c4:42
aa:1b:66:fe:c4:43
brightness