Instruction manual Digital 9000 System

Digital 9000 | 65
Using the EM 9046
“Load config” – Loading a configuration
The “load config” menu item allows you to load up to 10 saved settings of
your system configuration (see also the “save config” menu item).
In addition, you can ...
• load the last configuration saved (“last”).
• load the default configuration (“defaults”). In this case, the settings of
the menu items mentioned in the section “save config” are reset to their
factory defaults.
“Save config” – Saving a configuration
Via the “save config” menu item, you can save your system configuration
on up to 10 storage memories.
The settings of the following menu items are saved:
Display Status of the cable attenuation
“ok” The cable attenuation has been measured and is
automatically compensated for.
“Too high” The cable attenuation has been measured and is too high. It
cannot be automatically compensated for. The reception of
weaker signals is compromised.
왘 Check and optimize the installation between the EM 9046
and the antenna boosters.
Always use GZL 9000 system cables to obtain optimum attenuation
values.
Menu Menu item Page
Main menu
“System setup”
Output level 63
Word clock 64
Network | name of the network 66
Network | IP settings 66
Brightness 66
Extended menu
“Service setup”
Date & time | selected time zone 69
defaults
load config
modified