Instruction manual Digital 9000 System

Product overview
18 | Digital 9000
Overview of the rear panel
The overview of the rear panel shows an EM 9046 receiver equipped with the fixed PSU, CCC and ASP modules
and the optional DRX, DAO and AAO modules. The configuration shown is an example configuration. The inter-
changeable modules are highlighted in color.
Your Sennheiser service partner can configure the EM 9046 as follows:
• 1 to 8 EM 9046 DRX receiver modules
•1 AAO analog audio out module and 1 DAO digital audio out module or
•2 AAO analog audio out modules or
•2 DAO digital audio out modules
H
D
E
D
E
AB DCEF
G
H
I
I
4
G
H
3
1
2
A
0
C
5
E
F
9
B
D
I
J
8
7 6
K
1 ON/OFF switch
2 IEC mains socket, 3-pin
3 LAN UP socket
4 LAN DOWN socket
5 SERVICE interface
6 LAN UP LED
7 LAN DOWN LED
8 WORD CLOCK OUT socket (BNC),
looped-through output (75 )
9 WORD CLOCK IN socket (BNC), input (75 )
0 Blanking plate for aux opening
A XLR-3 sockets (male) for digital audio outputs
1/2 to 7/8, balanced, AES3
B DIGITAL MUTLICORE socket (sub-D, 25-pin), digital, balanced
C XLR-3 sockets (male) for analog audio outputs
1 to 8, transformer balanced
D ANALOG MULTICORE socket (sub-D, 25-pin), analog,
transformer balanced
E RF IN A socket (N-type), antenna input,
12 V out, max. 200 mA, 50 
F RF
IN B socket (N-type), ante
nna input,
12 V out, max. 200 mA, 50 
G RF
OUT A socket (N-type
), daisy chain output
H RF OUT B socket (N-type), daisy chain output
I EM 9046 type plate
J DRX receiver modules 1 ... 8
K Ventilation openings
A | PSU – power supply unit
B | CCC – clock core controller
C | Aux opening for optional extensions
D | DAO – digital audio out
E | AAO – analog audio out
F | ASP – antenna splitter
G | Type plate
H | DRX – receiver modules
I | Ventilation openings