Instruction manual SK 2000

20
Synchronizing the bodypack transmitter with a receiver
Synchronizing the bodypack transmitter
with a receiver
When synchronizing the bodypack transmitter with a receiver, please
observe the following:
Synchronizing the bodypack transmitter with the
receiver – individual operation
Upon delivery, the bodypack transmitter and the receiver are synchro-
nized with each other. However, if you cannot establish a transmission link
between bodypack transmitter and receiver, you have to synchronize the
channels of the devices.
For information on automatic synchronization of the bodypack trans-
mitter with the receiver (individual operation), refer to the instruction
manual of the receiver. This information is marked with the icon.
Alternatively, you can set the channel on the bodypack transmitter
manually:
왘 Make sure that you set the bodypack transmitter to the same
frequency bank and the same channel as the receiver.
If you still cannot establish a transmission link, refer to the chapter “If a
problem occurs ...” on page 21.
Synchronizing bodypack transmitters with
receivers – multi-channel operation
Combined with 2000 series receivers, 2000 series bodypack transmitters
can form transmission links that can be used in multi-channel systems.
For information on automatic synchronization of bodypack transmitters
with receivers (multi-channel operation), refer to the instruction manual
of your receiver.
For more information on multi-channel operation, visit the SK 2000
product at www.sennheiser.com.
왘 Only use a transmitter and a receiver from the same frequency
range (see the type plates on the transmitter and the
receiver).
왘 Make sure that the desired frequencies are listed in the
enclosed frequency information sheet.
왘 Make sure that the desired frequencies are approved and legal
in your country and, if necessary, apply for an operating
license.