Instruction manual SK 2000

11
Using the bodypack transmitter
Using the bodypack transmitter
To establish a transmission link, proceed as follows:
1. Switch the bodypack transmitter on (see next section).
2. Switch the receiver on (see the instruction manual of the receiver).
The transmission link is established and the display backlighting of the
receiver changes from red to orange.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing the bodypack transmitter with a
receiver” on page 20.
Switching the bodypack transmitter on/off
왘 Push the two battery compartment catches 쐈 and open the battery
compartment cover 쐅.
To
switch the bodypack transmitter on (online operation):
To
switch the bodypack transmitter on and to deactivate the RF signal on
sw
i
tch-on (offline operation):
It is vital to observe the notes on frequency selection on page 20.
왘 Briefly press the ON/OFF button 씈.
The “Frequency/Name” standard display appears on the
displa
y panel. The red ON LED 쐏 lights up and the transmis-
sion icon 햵
is displayed. The bodypack transmitter transmits
an R
F signal.
왘 Keep the ON/OFF button 씈 pressed until “RF Mute Off?”
appears on the display panel.
쐈
쐈
쐅
햵
씈
쐏
ON/OFF
ON/OFF