Instruction manual
Table Of Contents
- Important safety instructions
- Package contents
- Product overview
- Putting the RS 5000 into operation
- Setting up the transmitter
- Connecting the transmitter to an audio source
- Connecting the transmitter to the power supply system
- Charging the stethoset receiver’s rechargeable battery
- Displaying the remaining operating time of the rechargeable battery
- Using the charging reminder function
- Selecting and replacing the ear pads
- Using the RS 5000
- Cleaning and maintaining the RS 5000
- Using additional functions
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Using additional functions
32 | RS 5000
Hearing profile and balance protection
This setting is saved on the stethoset receiver, independent of the
transmitter you are using.
왘 Make sure that your stethoset receiver’s balance setting and
hearing profile are correctly adjusted (see page 23 and 24).
왘 Make sure that the protected settings mode is activated (see
page 30).
왘 Place the stethoset receiver into the transmitter’s charging com-
partment.
왘 Press the volume button + on the stethoset receiver to activate
or deactivate the hearing profile and balance protection.
* factory setting
왘 Save the setting by disconnecting the transmitter from the
power supply system (see page 30).
Status and display of
the protection
function
Function/behavior
activated
2
nd
LED segment lit
The activated hearing profile and the
balance setting cannot be changed/
deactivated.
deactivated*
2
nd
LED segment off
The hearing profiles can be changed at any
time by pressing the
Hearing profile
button for 2 seconds. The balance setting
can be changed.
If you are using several stethoset receivers and want to pro-
tect the activated hearing profiles from accidental adjust-
ment, you can place the stethoset receivers, one after the
other, into the transmitter’s charging compartment to acti-
vate the hearing profile and balance protection.
+
+