Instruction manual

Using additional functions
RS 5000 | 31
Battery status display
This setting is saved on the transmitter, independent of the ste-
thoset receiver you are using.
To change the battery status display:
왘 Make sure that the protected settings mode is activated (see
page 30).
왘 Press the Balance button L.
* factory setting
왘 Save the setting by disconnecting the transmitter from the
power supply system (see page 30).
Charging reminder function
This setting is saved on the transmitter, independent of the ste-
thoset receiver you are using.
To activate or deactivate the function:
왘 Make sure that the protected settings mode is activated (see
page 30).
왘 Press the Balance button R.
* factory setting
왘 Save the setting by disconnecting the transmitter from the
power supply system (see page 30).
Status and display of
the Battery LED
Function/behavior
permanently
activated (operation
and charging)*
1
st
LED segment lit
The current charge status is permanently
displayed during charging.
The remaining charge status is
permanently displayed during operation.
activated for
30 seconds
(operation and
charging)
1
st
LED segment off
The current charge status is displayed for
30 seconds during charging. Then all LEDs
go off. The charging process is continued.
The remaining charge status is displayed
for 30 seconds during operation. The
battery status display then goes off.
Status and display of
the charging
reminder function
Function/behavior
activated*
3
rd
LED segment lit
When you switch the stethoset receiver off
and the transmitter switches to standby
mode, the battery status display will flash
for 10 minutes to remind you to charge the
stethoset receiver.
deactivated
3
rd
LED segment off
After switching the wireless headphone
system off, all LEDs remain off.