Instruction manual and frequently asked questions - Evolution Wireless Digital (EW-D | EW-DX)

EW-D ASA antenna splitter
213
Installing the EW-D ASA in a rack
ATTENTION
Rack mounting poses risks
When installing the device in a closed 19" rack or multi-rack
assembly, please consider that, during operation, the ambient
temperature, the mechanical load and the electrical potentials
will be different from those of devices which are not mounted
into a rack.
▷ Make sure that the ambient temperature within the rack
does not exceed the permissible temperature limit stated
in the specifications. See „SPECIFICATIONS“.
▷ Ensure sufficient ventilation; if necessary, provide addi-
tional ventilation.
▷ Make sure that the mechanical load of the rack is even.
▷ When connecting to the power supply system, observe the
information indicated on the type plate. Avoid overloading
the circuits. If necessary, provide overcurrent protection.
▷ When mounting in a rack, please note that intrinsically
harmless leakage currents of the individual power supply
units may accumulate, thereby exceeding the permissible
limit value. As a remedy, ground the rack via an additional
ground connection.
To mount the antenna splitter in a rack, you will need the GA 3
rack mount kit (optional accessory).
Rack mounting is carried out in the same way as for the EW-
D EM receiver: „Installing receivers in a rack“.