Instruction manual ew 100 P G4

Table Of Contents
Using the SKM 100 G4
82
Advanced > Tune menu item
Configuring the transmission frequency and frequency bank U
When you have configured the wireless microphone to a system bank and
you call up the Tune menu item, channel 1 of the frequency bank U is auto-
matically set. The message U.1 briefly appears in the display. In the factory
settings, the channels of the frequency bank U are not assigned to any
transmission frequency.
While you work in the Tune menu, the RF signal is deactivated.
You can configure a transmission frequency for the current channel or se-
lect a channel in the frequency bank U and configure a transmission fre-
quency for this channel in the Tune menu. Be sure to note the information
on frequency selection, see “Setting notes”.
Only adjusting the frequency
To configure the transmission frequency for the current channel:
Open the Tune menu item in the Advanced menu.
The frequency selection appears.
Configure the desired frequency.
Press the multi-function switch.
Your settings will be saved. You are now back in the operating menu.
Setting the channel and frequency
To select a channel and assign it a frequency:
Move the multi-function switch until the Tune menu item appears.
Hold down the multi-function switch until the frequency bank selection
appears.
Set the desired channel.
Press the multi-function switch.
The frequency selection appears.
Configure the frequency.